In this paper, a specific type of Boron Carbide (B4C) with a high enrichment of 80 ± 0.3 at% 10B was prepared as an absorbing material for control rods in nuclear reactors. The enrichment of 10B was achieved using a chemical exchange method, followed by obtaining boron carbide powder through a carbothermal reduction method. Finally, B4C with a high enrichment of 68.3~74.2% theoretical density was obtained using a hot-pressed sintering process. This study focused on investigating the basic out-of-pile thermophysical properties of the high enrichment B4C compared to natural B4C reference pellets under non-irradiated conditions. These properties included the thermal expansion coefficient, thermal conductivity, emissivity, elastic limit, elastic modulus, and Poisson’s ratio. The research results indicate that the enriched B4C pellet exhibits good thermal stability and meets the technical requirements for mechanical capability. It was observed that porosity plays a significant role in determining the out-of-pile mechanical capability of B4C, with higher porosity samples having a lower thermal conductivity, elastic–plastic limit, and elastic modulus. In short, all the technical indexes studied meet the requirements of nuclear-grade Boron Carbide pellets for Pressurized Water Reactors.
Depositing a tritium permeation barrier on the surface of materials is a key method for reducing tritium permeability. During actual operational processes, the surface of the tritium permeation barrier may experience mechanical damage, such as spalling and scratches. The hydrogen permeability resistance of the coating will degrade due to such forms of mechanical damage. It is a significant engineering challenge to evaluate the impact of these damages on the coating’s tritium resistance. In this experiment, the mechanical damage to the FeAl/Al2O3 tritium permeation barrier on 316L stainless steel was simulated through scratching, debonding, and thermal shock. Subsequently, a hydrogen isotope gas drive permeation (GDP) test was conducted. The influence of the degree of mechanical damage on the coating’s tritium permeation behavior was assessed and discussed. The results indicate that, under the same damage mechanism, the coating’s tritium permeability resistance is positively correlated with the integrity of the coating. Additionally, the impact of scratches on the coating surface is more severe than that of other damage mechanisms.
The permeation of tritium from secondary neutron source rods in nuclear power plants presents a significant and unavoidable safety concern both for internal equipment and the external environment. This study primarily explores two feasible strategies for tritium permeation barriers: coating stainless steel surfaces with tritium permeation barrier (TPB) materials and utilizing materials with excellent tritium absorption properties. Through external ion irradiation tests, a comparative analysis was conducted on the tritium permeation performance, morphology, and nanohardness changes in two tritium-resistant designs, specifically Cr2O3/Al2O3 composite coatings and a zirconium-based tritium-absorbing material under varying irradiation doses. The results indicate that both approaches exhibit exceptional radiation resistance, maintaining an effective tritium permeation reduction factor (PRF) even after irradiation.
The permeation of tritium from secondary neutron source rods in nuclear power plants presents a significant and unavoidable safety concern for both internal equipment and the external environment. This study primarily explores two feasible strategies for tritium permeation barriers: coating stainless steel surfaces with tritium-permeation-barrier (TPB) materials and utilizing materials with excellent tritium absorption properties. Through external ion irradiation tests, a comparative analysis was conducted on the tritium permeation performance, microstructure, and nano-hardness changes of two tritium-resistant designs, specifically Cr2O3/Al2O3 composite coatings, and a zirconium-based tritium-absorbing material under varying irradiation doses. The results indicate that both approaches exhibit exceptional radiation resistance, maintaining an effective tritium permeation reduction factor (PRF) even after irradiation.