The effect of cryogenic treatment (CT) on the microstructure, residual stress, and dimensional stability of 7075 aluminum alloy under temperatures of 0 °C, −60 °C, −120 °C, and −196 °C were studied, using optical microscopy (OM), scanning electron microscopy (SEM), transmission electron microscopy (TEM), an X-ray diffractometer, and an X-ray stress tester. The results indicated that CT can facilitate the dissolution of the coarse secondary phase into the α(Al) matrix, promote uniform distribution of Mg, Cu, Zn elements, and increase the density of fine secondary phases in the 7075 Al alloy. The CT can also induce the rotation of the α(Al) grain towards (200), through the processes of recovery and recrystallization. It was found that the residual stress was released, and a higher dimensional stability of the 7075 aluminum alloy was achieved, after CT. Experimental results demonstrated that the optimum CT temperature for the 7075 aluminum alloy is −120 °C.

The effect of high pressure (135 MPa) and the following heat treatment on the microstructure and micro-hardness of the squeezing cast AlSi9CuMg alloy is investigated, using optical microscopy (OM), Vickers tester, scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The results indicate that the application of high pressure can increase under-cooling and the cooling rate during solidification and cause the refinement of the microstructure. The enhanced melt flow resulting from high pressure can also break the dendrite to form the spherical and elliptical primary α (Al) grains during the early stage of solidification. The winter-sweet flower-shaped primary α (Al) phases can also be formed through plastic deformation caused by the flow of the partially solidified melt. The ageing treatment results showed that a maximum (peak) micro-hardness value was obtained for each of the three ageing temperatures at different ageing times, and the highest peak value was achieved at 175 °C for 480 min. The micro-hardness change of the sample under different ageing processes was attributed to the variation of type, density, and size of the precipitates.

The effects of the thermal cyclic aging treatment on the microstructure and mechanical properties of 2060 Al-Li alloy laser beam welded joints were investigated. Aging treatments were conducted at different temperatures and for different cycles. Test results showed that the tensile strength of the weld joints increased and the elongation slightly decreased after the thermal cycling treatment. It was also found that the heat affected zone (HAZ) of the welds exhibited a significant increase in microhardness, whilst the microhardness variation of the nondendrite equiaxed zone (EQZ) can be neglected. The strengthening effect of the thermal cycling became more obvious as the temperature and cycles increased. The highest strength of around 513 MPa (96% of the base metal) was obtained at the temperature of 180 degrees C. Reprecipitation of strengthening phases such as T1 in the HAZ at 180 degrees C was observed by TEM, which can be considered as the main reason for the strengthening effect of the aging treatment.