The improvement of the safety, specific energy, cycle life and the cost reduction of Li‐ion batteries are hot research topics. Now, in the pursuit of high energy density, the employed high‐energy‐density cathode/anode materials and the increased operation voltage challenge the prevalent electrolyte formula, like the existing ester and ether electrolytes cannot withstand the high‐voltage operation and high‐capacity anode such as lithium (Li), silicon (Si) and silicon‐graphite (Si−C) composite anode. It is recognized that stable electrolyte‐electrode interfaces can avoid the electrolytes side reactions and protect the electrode materials. Up to now, various additives have been developed to modify the electrode‐electrolyte interfaces, such as famous 4‐fluoroethylene carbonate, vinylene carbonate and lithium nitrate, and the LIBs and lithium metal batteries (LMBs) performances have been improved greatly. However, the lifespan of the higher‐energy‐density batteries with Li/Si/Si−C anode and high‐nickel layer oxides cathode materials cannot meet the request due to the lack of ideal electrolyte formula. In this review, we present a comprehensive and in‐depth overview on the electrolyte additives, especially focused on multifunctional additives, the reaction mechanisms of various additives and fundamental design. Finally, novel insights, promising directions and potential solutions for the multifunctional electrolyte additives are proposed to motivate high‐energy‐density Li battery chemistries.
In this work, the silica in rice husk was removed to create a natural template to prepare porous activated carbon. The preparation process of the activated carbon (AC) from waste rice husk consisted of carbonization, silica removal and activation. Factors affecting the preparation of AC, including the mass ratio of ZnCl2 and rice husk carbon (RHC), activation temperature and time were investigated. Based on the Brunauer–Emmett–Teller (BET) results, the specific surface area of AC prepared under optimized conditions was as high as 1673.25 m2 g−1. Then, magnetic activated carbon (mag-AC) was synthesized by in situ co-precipitation of rice husk-based activated carbon and Fe3O4. The specific surface area and average pore diameter of mag-AC were respectively 986.97 m2 g−1 and 3.62 nm, respectively. It was shown that mag-AC was a viable adsorbent for magnetic extraction of tetracycline antibiotics in water samples followed by quantification by HPLC-MS/MS. The results indicated satisfactory correlation coefficients (R2) ranging from 0.9955 to 0.9998. Limits of detection (LOD) and quantization (LOQ) were achieved in the range of 0.10 to 0.95 and 0.35 to 2.85 μg L−1 in water samples, respectively.
28 April 2023 in Journal of Colloid and Interface Science