Recent studies have showed that microindentation techniques allow assessing the logarithmic creep rate of a cement paste in good correlation with the long-term creep rates measured by compressive tests at macroscopic scale. After having applied microindentation techniques to characterize the effect of relative humidity (RH) on both the creep and relaxation behavior of a cement paste, the objective of this work is to analyze the duality between creep and relaxation curves by means of the analytical models which are currently employed in open literature. First, large grids of creep and relaxation microindentation tests were carried out on a cement paste sample in hygral equilibrium at different levels of RH. Thus, the results were modeled by a viscoelastic model by considering different creep functions (logarithmic and power-law) and corrective terms for initial plasticity under loading. The presented results provide new insights to understand the duality between creep and relaxation rates of a cement paste measured at micrometer scale, especially considering the possible plastic effect.
Despite decades of extensive studies, the mechanism of concrete creep remains a subject of debate, mainly due to the complex nature of cement microstructure. This complexity is further amplified by the interplay between water and the cement microstructure. The present study aimed to better understand the creep mechanism through creep tests on microprisms of cement paste at hygral equilibrium. First, microprisms with dimensions of 150 mm × 150 mm × 300 mm were prepared by precision cutting from a cement paste specimen with a water-to-cement ratio of 0.4. Subsequently, uniaxial compression and creep tests were carried out on these microprisms in a chamber with controlled relative humidity (RH). To mitigate the impact of plasticity and damage, the applied peak load was set to generate a stress level that was approximately 40% of the compressive strength. Moreover, an analytical coefficient was formulated to account for the foundation effect on microprism creep, agreeing with the numerical analysis employing the finite element method. Our findings showed that the microscale creep compliance varied when the RH level was changed from 90% to 11%. Furthermore, logarithmic and power-law models were both applied to simulate creep curves. Lastly, the modeled creep behaviors were compared with those obtained by microindentation experiments in previous studies.
28 October 2022 in Journal of Petroleum Science and Engineering