The versatile family of nanoparticles is considered to have a huge impact on the different fields of materials research, mostly nanoelectronics, catalytic chemistry and in study of cytocompatibility, targeted drug delivery and tissue engineering. Different approaches for nanoparticle preparation have been developed, not only based on “bottom up” and “top down” techniques, but also several procedures of effective nanoparticle modifications have been successfully used. This paper is focused on different techniques of nanoparticles’ preparation, with primary focus on metal nanoparticles. Dispergation methods such as laser ablation and vacuum sputtering are introduced. Condensation methods such as reduction with sodium citrate, the Brust–Schiffrin method and approaches based on ultraviolet light or biosynthesis of silver and gold are also discussed. Basic properties of colloidal solutions are described. Also a historical overview of nanoparticles are briefly introduced together with short introduction to specific properties of nanoparticles and their solutions.

We studied the electrical and optical properties, density, and crystalline structure of Au nanostructures prepared by direct current sputtering on glass. We measured temperature dependence of sheet resistance and current-voltage characteristics and also performed scanning electron microscopy [SEM] analysis of gold nanolayers. It was shown that within the wide range of temperatures, gold nanolayers (<10 nm) exhibit both metal and semiconducting-like type of conductivity. UV/Vis analysis proved the semiconducting characteristic of intrinsic Au clusters. SEM analysis showed the initiatory stadium of gold layer formation to be running over isolated islands. Gold density calculated from the weight and effective thickness of the layers is an increasing function of the layer thickness up to approximately 100 nm. In thin layers deposited on solid surface, a lattice expansion is observed, which is manifested in the increase of the lattice parameter and the decrease of metal density. With increasing layer thickness, the lattice parameter and the density approach the bulk values.

Here, poly(N‐acryloylglycinamide‐co‐vinyltriazole) p(NAGA‐co‐VTZ) supramolecular polymer hydrogel doped with carbonized and activated polypyrrole nanotubes as a high‐strength self‐healable material is presented for supercapacitors. Initially, the p(NAGA‐co‐VTZ) hydrogel films are synthesized by photopolymerization of N‐acryloylglycinamide and 1‐vinyl‐1,2,4‐triazole without the use of any cross‐linkers. The hydrogels demonstrated remarkable self‐healing ability via hydrogen bonding at temperatures above upper critical solubility temperature, excellent mechanical properties (0.86 MPa), large stretchability (1300%) and cut resistance. Subsequently, carbonized and ethanol/KOH‐activated polypyrrole nanotubes (acNTs) are prepared as the active material for electrochemical double‐layer capacitors (EDLC). Then, a symmetric self‐healable supercapacitor employing p(NAGA‐co‐VTZ) hydrogel, acNTs and aqueous 3 m KCl solution is assembled. Cyclic voltammetry and galvanostatic charge–discharge measurements show that the prepared device gives a specific capacitance of 282.62 F g⁻¹ at 0.2 A g⁻¹ and a high areal capacitance of 316.86 mF cm⁻² at a scan rate of 10 mV s⁻¹. Importantly, the supercapacitor operates over a wide voltage window (0–1.2 V) and provides excellent cyclic performance with capacitance retention of 97% after 10 000 cycles and 94% after self‐healing. In summary, the developed self‐healable supercapacitor exhibits considerable potential as a high‐performance energy storage device.