A Bragg-mirror-assisted terahertz (THz) high-contrast and broadband plasmonic interferometer is proposed and theoretically investigated for potential sensing applications. The central microslit couples the incident THz wave into unidirectional surface plasmon polaritons (SPPs) waves travelling to the bilateral Bragg gratings, where they are totally reflected over a wide wavelength range back towards the microslit. The properties of interference between the SPPs waves and transmitted THz wave are highly dependent on the surrounding material, offering a flexible approach for the realization of refractive index (RI) detection. The systematic study reveals that the proposed interferometric sensor possesses wavelength sensitivity as high as 167 μm RIU⁻¹ (RIU: RI unit). More importantly, based on the intensity interrogation method, an ultrahigh Figure-of-Merit (FoM) of 18,750% RIU⁻¹, surpassing that of previous plasmonic sensors, is obtained due to the high-contrast of interference pattern. The results also demonstrated that the proposed sensors are also quite robust against the oblique illumination. It is foreseen the proposed configuration may open up new horizons in developing THz plasmonic sensing platforms and next-generation integrated THz circuits.

Graphene, a two-dimensional monatomic layer of carbon material, has demonstrated as a good candidate for applications of ultrafast photodetectors, transistors, transparent electrodes, and biosensing. Recently, many studies have shown that using metallic deep gratings could enhance the absorptance of graphene of 2.3% up to 80% in the near infrared region for applications in photon detection. This paper presents utilizing a nanograting structure, namely, a compound metallic grating could greatly enhance the absorptance of graphene to 100% and widen its spectral bandwidth to 600 nm, which are greater than those of previous work. The study also showed that the absorptance spectrum is insensitive to angles of incidence. Furthermore, the proposed graphene-covered compound grating might bring a lot of benefits for graphene designs-based optical and optoelectronic devices.

Developing efficient techniques to bridge single-plasmon radiations to nanoscale plasmonic waveguides nowadays is still a critical consideration for on-chip integration of solid-state photonic circuits. Here, we propose and theoretically demonstrate the generation and routing of single plasmons in nanowire-based hybrid plasmonic coupling structures with nanodisk antenna resonators. Optimizations of key characteristic parameters illustrate that the structure not only offers an enhanced tradeoff between the propagation length (20m) and mode confinement (2/8450), but also exhibits outstanding plasmon generation and guiding properties, such as a Purcell factor of 2.14 106, a coupling efficiency from emissions to desired waveguides of 59%, and a Figure-of-Merit of 3 107 in the visible and infrared spectral range, which outperforms the previous plasmonic structures. The plasmon emission properties are also quite robust against possible emitter positioning imperfections. Our work may inspire new opportunities in helping design quantum-plasmonic platforms for future quantum information processing and related on-chip plasmonic devices

This paper proposes an optical sensor based on nanoscale metamaterial structures. The design of the sensor has been explored with respect to biosensing applications through numerical modeling and analysis. The sensor comprises silica substrate and diamond nanostructures, both of which represent dielectrics. The sensing principle is based on the detection of ambient refractive index change. As the analyte properties change, the refractive index changes, as well. The refractive index change has been detected by striking electromagnetic waves onto the structure and noting the spectral response. Ultraviolet waves have been utilized for recording spectral responses and evaluating sensor performance. The sensor displays multiple sharp resonance peaks in the reflected beam. By altering the refractive index of the analyte present around the sensor, the peaks can be seen choosing different wavelengths. The resonance peaks have been investigated to observe electric and magnetic field dipoles in the sensor structure. The spectrum peaks have also been studied to understand fabrication tolerances. The sensor displays a linear response, along with a large Quality (Q) factor. The maximum value of the achieved Quality (Q) factor for the proposed sensor is 1229 while operating across the refractive index range of 1.4–1.45. The claim has been supported by comparison with contemporary works on similar platforms. A range of other sensing parameters have also been calculated and benchmarked. Metamaterial-based optical sensors can provide smaller device sizes, faster response times and label-free detection.