Lettuce (Lactuca sativa L.) and African catfish (Clarias gariepinus) were preferred to grow in aquaponics due to their high and fast productivity growth. However, limited research was conducted on the impact on different inorganic substrates‘ growth performance in aquaponics. In this study, lettuce‘s growth performance was determined in four different kinds of inorganic substrates in Nutrient Film Technique (NFT) aquaponics by measuring final weight, daily growth rate, stem diameter, plant and root lengths, leaf number per plant and shoot/root ratio. Polyester fiber, rock wool, zeolite, and gravel were used as inorganic substrate materials. A constant flow rate of 0.3 L/min was maintained using with a submersible pump motor. At the end of the study, the African catfish‘s feed conversion ratio was estimated to be 0.66, while the specific growth rate (SGR) was 2.3%. Total lettuce yields for polyester fiber, rock wool, zeolite and gravel were obtained as 5.072,22 kg/m2, 4.934,03 kg/m2, 6.067 kg/m2, and 5.382,64 kg/m2 respectively. There were statistically significant differences for daily growth rate between the inorganic substrates that the significantly highest values were recorded in the zeolite. The results revealed that initial plant length and shoot/root ratio were the significant factors on the growth performance for lettuce in aquaponic system tested. The best lettuce yield performance was observed in zeolite substrate but, economically available option was found as gravel for hydroponic troughs.
15 September 2023 in Ege Journal of Fisheries and Aquatic Sciences
Aquaponics are promising and sustainable technologies consisting of fish-plant-bacteria consortia in the same system, thereby providing an environmentally friendly system by recycling water and nutrients. This study was planned to investigate the influence of varying hydraulic loading rates (HLR) on the growth of basil plant (Ocimum basilicum L. ‘Genovese’) in a low-cost of electricity nutrient film technique aquaponics (NFT) integrated with African catfish (Clarias gariepinus (Burchell)) under the Eastern Mediterranean climate conditions, Antalya, Türkiye. The hydraulic loading rates tested in plant-growing troughs 2, 4, 8, and 12 m3/m2/day. African catfish showed an excellent feed conversion ratio (0.695) over the experiment. There was no statistically significant difference in plant height, number of leaves, and stem diameter for basil plants, but a statistically significant difference was found in plant weight and leaf area. The best plant weight gain was observed in the 4 m3/m2/day group with 23.0±2.5 g mean weight. The optimum HLR for basil production was estimated as 4.41 m3/m2/day based on yield (kg/m2) and energy consumption (KWh/kg basil) in a basil-African catfish integrated NFT aquaponics. The optimum HLR can maximize production without further increase of energy expenditure. Higher HLRs of 4.41 increase energy cost per unit of basil production.
Freshwater lakes provide essential ecosystem services yet remain far less studied for microplastic (MP) pollution than marine ecosystems. This study provides a comparative, Multi-lake assessment of MP contamination in the surface water and sediment of twelve lakes in the Southern regions of Türkiye, sampled over four campaigns between May 2024 and September 2025. MPs were quantified under a stereomicroscope and their polymers verified by μ-Raman spectroscopy; all reported concentrations are blank- and polymer-verification-corrected. Surface-water MP concentrations averaged 157,965 ± 189,191 MPs km⁻² (median 79,651; range 0–913,116), with the highest lake means in Köyceğiz, Burdur, Salda and the lowest in Yazır, Beyşehir and Bafa. Sediment concentrations averaged 75.1 ± 67.8 MPs kg⁻¹ dry weight (median 50; range 0–380), peaking in the desiccated Karataş lakebed and in Avlan, Beyşehir and Gölcük. Fibres and fragments dominated both matrices, with the fibre proportion rising from surface water (47.8%) to sediment (58.0%). Polymer composition differed markedly between matrices: polyethylene (37.1%) prevailed in surface water, whereas the denser polyethylene terephthalate (27.9%) and polyamide characterised sediment, consistent with density-driven vertical partitioning. Inter-lake and inter-period differences were statistically significant for surface water but not for sediment, indicating a more temporally integrative behaviour of the sediment compartment. Elevated loads in protected, oligotrophic and even fully desiccated lakes indicate that, alongside catchment sources (textiles, fisheries, agricultural plastics, packaging and tourism), atmospheric deposition is an important pathway. The dataset offers a comparable baseline for Turkish freshwater ecosystems and underscores the need for standardised national monitoring.
In this study, Chlorella minutissima, Botryococcus braunii, and Haematococcus pluvialis were selected to culture in Blue-Green 11 (BG-11) media, remineralized sludge water (RSW), and RSW including trace element solution (RSW+Mn) for 28 days. Post-harvest, amino acid and fatty acid profiles were determined. The total amino acid (ΣAA) content was observed in C. minutissima, measuring 68.62±6.35 g/100g, when cultivated in BG-11 culture media. The highest total fatty acid content was found in B. braunii, calculating 95.19±1.38 g/100g, when cultivated in BG-11 culture media. The total content of monounsaturated fatty acids was high compared to polyunsaturated fatty acids (PUFAs) in all groups. This study demonstrates the potential of C. minutissima, B. braunii, and H. pluvialis as a valuable source of essential amino and fatty acids. Among the 171 amino acid comparisons across different culture media, only five (aspartic acid, alanine, cysteine, phenylalanine, and isoleucine in Botryococcus braunii) exhibited statistically significant differences (P<0.05), suggesting that the overall amino acid composition remained relatively stable despite changes in medium formulation. No statistically significant differences were observed among the microalgae species in terms of their fatty acid profiles.
Freshwater lakes provide essential ecosystem services yet remain far less studied for microplastic (MP) pollution than marine ecosystems. This study provides a comparative, Multi-lake assessment of MP contamination in the surface water and sediment of twelve lakes in the Southern regions of Türkiye, sampled over four campaigns between May 2024 and September 2025. MPs were quantified under a stereomicroscope and their polymers verified by μ-Raman spectroscopy; all reported concentrations are blank- and polymer-verification-corrected. Surface-water MP concentrations averaged 157,965 ± 189,191 MPs km⁻² (median 79,651; range 0–913,116), with the highest lake means in Köyceğiz, Burdur, Salda and the lowest in Yazır, Beyşehir and Bafa. Sediment concentrations averaged 75.1 ± 67.8 MPs kg⁻¹ dry weight (median 50; range 0–380), peaking in the desiccated Karataş lakebed and in Avlan, Beyşehir and Gölcük. Fibres and fragments dominated both matrices, with the fibre proportion rising from surface water (47.8%) to sediment (58.0%). Polymer composition differed markedly between matrices: polyethylene (37.1%) prevailed in surface water, whereas the denser polyethylene terephthalate (27.9%) and polyamide characterised sediment, consistent with density-driven vertical partitioning. Inter-lake and inter-period differences were statistically significant for surface water but not for sediment, indicating a more temporally integrative behaviour of the sediment compartment. Elevated loads in protected, oligotrophic and even fully desiccated lakes indicate that, alongside catchment sources (textiles, fisheries, agricultural plastics, packaging and tourism), atmospheric deposition is an important pathway. The dataset offers a comparable baseline for Turkish freshwater ecosystems and underscores the need for standardised national monitoring.
Freshwater lakes provide essential ecosystem services yet remain far less studied for microplastic (MP) pollution than marine ecosystems. This study provides a comparative, multi-lake assessment of MP contamination in the surface water and sediment of twelve lakes in the Southern regions of Türkiye, sampled over four campaigns between May 2024 and September 2025. MPs were quantified under a stereomicroscope and their polymers verified by μ-Raman spectroscopy. All reported concentrations are polymer-verification-corrected. Surface-water MP concentrations averaged 157,965 ± 189,191 MPs km⁻² (median 79,651; range 0–913,116), with the highest lake means in Köyceğiz, Burdur, Salda and the lowest in Yazır, Beyşehir and Bafa. Sediment concentrations averaged 75.1 ± 67.8 MPs kg⁻¹ dry weight (median 50; range 0–380), peaking in the desiccated Karataş lakebed and in Avlan, Beyşehir and Gölcük. Fibres and fragments dominated both matrices, with the fibre proportion rising from surface water (47.8%) to sediment (58.0%). Polymer composition differed markedly between matrices: polyethylene (37.1%) prevailed in surface water, whereas the denser polyethylene terephthalate (27.9%) and polyamide characterised sediment, consistent with density-driven vertical partitioning. Inter-lake and inter-period differences were statistically significant for surface water but not for sediment, indicating a more temporally integrative behaviour of the sediment compartment. Elevated loads in protected, oligotrophic and even fully desiccated lakes indicate that, alongside catchment sources (textiles, fisheries, agricultural plastics, packaging and tourism), atmospheric deposition may also contribute. The dataset offers a comparable baseline for Turkish freshwater ecosystems and underscores the need for standardised national monitoring.