Using artificial neural networks (ANN), numerous models were developed for predicting the ultimate shear strength of reinforced concrete deep beams. Many experimental result databases from earlier research were carefully gathered for this study. Two hundred fifty-three findings from experiments were included in this database. The ultimate shear strength was the output parameter, while ten factors were determined as input parameters for the ANN model based on the completed literature research. The required model was constructed using a back propagation neural network. The model of the neural networks was determined using the trial-and-error method. It was discovered that, inside the range of the input boundaries considered, the ANN model could accurately estimate the ultimate shear strength of deep beams. The measured shear strength and the shear strength predicted by the ANN model have a high correlation coefficient of 0.97, indicating a strong relationship between the predicted and actual values. The results show that, given the range of input parameters, ANN offers an excellent agreement of interest as a practical technique for estimating the ultimate shear strength. A parametric investigation was performed using the trained neural network model to assess how the input parameters affected the shear strength capacity of deep beams.
1 January 2025 in Research on Engineering Structures and Materials
Recently, many types of research in Iraq have had the properties of lightweight concrete beams utilizing both artificial and normal aggregate for economic reasons. Very limited works have been implemented to investigate the resistance of flexural and shear behavior of structural lightweight aggregate concrete; therefore, it is important to study the properties and their structural behavior. The present work is to investigate the shear and flexural strength of lightweight concrete beams made of pumice with silica fume admixture. The lightweight concrete has been made by partial replacement of crushed gravel with 75% pumice and 7% silica fume. The value of compressive force strength is 29 MPa within twenty-eight days. A total of ten reinforced concrete beams is used, with dimensions of (150 x 150 x 750) mm, with and without silica fume, and with varying ratios of transverse reinforcement (stirrups). The deflection at mid-span was also measured using a mechanical dial gauge. Normal-weight concrete beams are also used for comparison with the lightweight concrete beams. Beam behavior was assessed in terms of ultimate deflection, failure mode, and crack pattern. According to the experimental results, the prepared concrete's weight and strength met the LWC requirements. The results showed a significant effect of the transverse reinforcement ratio (stirrups), where the values of the shear and resistance of flexural rose when the amount of reinforcement increased. Furthermore, the appearance of the first crack has been significantly delayed as the reinforcement ratio rose.
31 December 2025 in Revue des composites et des matériaux avancés
In this paper, an ANN-based model is suggested for the prediction of shear strength of steel fiber-reinforced concrete (SFRC) beams without transverse reinforcements, and the model is developed directly using Excel software to ensure computational transparency and statistical interpretability, while remaining an empirical data-driven tool. In this study, a comprehensive database including 923 experimental data is collected, prepared and utilized to develop the neural network. Following the completion of the learning process, the ultimate weight and bias for the neural network are obtained. These parameters are employed in the Excel worksheet. With this process, the learned model is converted into a standalone and operational design tool. Sensitivity analysis, which has been performed through a step-by-step and perturbation method, revealed that the beam width (b) is the most influential parameter in the determination of shear strength (33.4%), followed by concrete compressive strength (fc, 17.1%) and effective depth (d, 15.3%). Then, a parametric study is conducted to study the effect of the shear span-to-depth ratio (a/d), longitudinal reinforcement ratio (ρ) and fiber aspect ratio (Lf/df) on the shear behavior of the members.