Identification of thermal resistance of the gas-gap between the ingot and mould, as well as the heat flux distribution on the phase change from the solid side during continuous casting of metals is the subject of this article. Analysed parameter estimation problems of the steady-state heat conduction belong to the group of inverse problems. The presented work shows the possibility of applying the least square adjustment method with a priori data for the identification of thermal resistance, the interphase location as well the heat flux distribution on the phase change from the solid side and the temperature field within the ingot and mould. The most important feature of the approach is that the unknown thermal resistance of the gas-gap is obtained from the temperature measurements at a number of sensors located in the wall of the mould, and some sensors located in the ingot, by solving the appropriate inverse problem. The validity of the solution of the inverse problem is checked by comparison with the results of direct problem. In this work, a front-tracking method with an automatic mesh generation finite element technique (so called deforming or moving finite-elements) for steady-state equation conduction-advection problems is developed. Such an approach makes it possible to find the exact solid-liquid interface location, because it is the integral part of the solution. Due to the strong convective nature of the problem (casting velocity, thermal parameters) the special up-wind technique is applied.
15 April 2025 in International Journal of Hydrogen Energy
Organic Rankine Cycle (ORC) technology is nowadays considered as interesting option for utilization of local biomass resources. The number of plants worldwide is constantly growing within typical range of electric power output form 0.2 to 3.0 MW. In such systems biomass combustion chambers with step or vibrating grates are used. Heat is transferred to the thermal oil in a separate spiral heat exchanger. The biggest problems in such system are variable and inaccurately predictable properties of biomass that directly influences operation of combustion equipment, and thus the performance of entire cogeneration plant. In this paper experiences from two plants are presented. The plants are located in Krosno (Poland) and in Ostfildern near Stuttgart, Germany. In the first one high quality wood chips are used whereas the second one is powered by low quality biomass with the mass ash content approaching 18%. Although similar, both plants use different strategies to control the combustion process. Long term measurements are used to develop biomass combustion models in the plants. The paper also presents results of implementation of the online optic measurement system for monitoring of biomass properties such as LHV, ash and water content.