The particle size of an electrode material is known to play an essential role in its electrochemical performance in Li-ion batteries. In Li–S batteries, porous host materials are applied to store sulfur and suppress the escape of polysulfides; yet the particle size of the host as an important parameter remains largely unexplored. Herein we chose ZIF-8, a metal–organic framework (MOF) proved promising for sulfur storage, as the proof-of-concept prototype, and systematically synthesized five sets of ZIF-8 samples of different particle sizes (from 1 μm), using them as S@MOF cathodes. The results show that sulfur utilization increases monotonically with the decrease of ZIF-8 particle size (950 mA h g−1 at 0.5 C), while the best cycling stability (75% over 250 cycles at 0.5 C) is achieved with a moderate size (∼200 nm).
9 January 2015 in ACS Applied Materials & Interfaces
Lithium plating may occur during charging, especially at high rates or overcharging conditions for lithium-ion batteries (LIBs), which would cause battery capacity degradation and even trigger thermal runaway. Thus, it is essential to detect lithium plating onset during the charging processes. Electrochemical impedance can reveal the dynamic electrode properties of the battery, which is promising for use in battery management systems for the online detection of lithium plating onset. In this article, the impedance at 1 Hz is measured during the over-discharge and fast discharge processes using lithium–graphite half-cells. For half-cells, the variation in graphite electrode potential vs. Li/Li+ during discharging is directly recorded. An equivalent circuit model is proposed and adopted to estimate the real lithium plating reaction overpotential, which is deemed the thermodynamic indicator of lithium plating and is used as validation for the detection of lithium plating onset. Through the auxiliary validation of the estimation of lithium plating overpotential and the shape of incremental capacity curves, the relationship between impedance changes at specific frequency and the lithium plating onset is revealed. The results lay a good foundation for proposing the online diagnostic method of lithium plating onset based on the in situ impedance.
Vehicle 12V lithium-ion battery is mainly used for automotive startup and low-voltage system power supply, and accurately estimate its state of charge (SOC) and operating voltage in time is essential to vehicle safety. For this, a joint estimation method for SOC and operating voltage of on-board 12V lithium-ion battery is proposed based on the second-order RC equivalent circuit model combined with the vehicle pre-charge conditions. In additional, the adaptive forgetting factor recursive least squares (AFFRLS) method is adopted to obtain circuit parameters, subsequently, double extended Kalman filter (DEKF) algorithm used to achieve SOC online estimation of 12V lithium-ion battery. Furthermore, combined with characteristic current curve under charging failure scenario, strategy for predicting the operating voltage of 12V lithium-ion battery is also proposed. Finally, a 12V 44Ah lithium-ion battery is selected to carry out the validation as proof of concept. The experimental results show that in the temperature range of 0 ℃ ~40 ℃ , the proposed joint estimation method has a maximum error of 1.6% in the SOC estimation and the accuracy of the operating voltage prediction is controlled within ±0.3%.