This article addresses the problem of increasing tool life by applying a wear-resisting coating. However, the lack of technology-based methods and optimal regimes complicate this process. A method for finishing plasma hardening of metals which allows evaluate the quality of the wear-resistant thin-film coatings and optimize application regimes have been advanced.
14 January 2016 in Journal of Physics: Conference Series
This paper presents the results of simulation of plasma deposition and hardening of coatings in modulating the electrical parameters. Mathematical models are based on physical models of gas-dynamic mechanisms more dynamic and thermal processes of the plasma jet. As an example the modeling of dynamic processes of heterogeneous plasma jet, modulated current pulses indirect arc plasma torch.
1 June 2016 in IOP Conference Series: Materials Science and Engineering
The article presents the results of experimental studies of the quality of cleaning steel surfaces by a glow discharge for plasma spraying. Shows the results of measurements of the angle of surface wetting and bond strength of the plasma coating to the surface treated. The dependence of the influence of the glow discharge power, chamber pressure, distance between the electrodes and the processing time of the surface on cleaning efficiency. Optimal fields of factors is found. It is shown increase joint strength coating and base by 30-80% as a result of cleaning the substrate surface by a glow discharge plasma spraying.
Plasma-spraying process with the use of indirect and direct arcs is taken up. The coat strengthening is realized by local weld penetration of the coat in equally spaced zones by power impulse modulation of the plasmotron direct arc. Theoretically estimated modes of strengthening, providing coat weld penetration till the transition zone of the coat base and satisfying the surface exploitation loads are presented.
1 November 2016 in IOP Conference Series: Materials Science and Engineering
This paper presents the results of simulation of plasma deposition and hardening of coatings in modulating the electrical parameters. Mathematical models are based on physical models of gas-dynamic mechanisms more dynamic and thermal processes of the plasma jet. As an example the modeling of dynamic processes of heterogeneous plasma jet, modulated current pulses indirect arc plasma torch.