Soil penetration resistance (SPR) is an important indicator for soil strength which not only affects the growth of crop roots and crop yield but also is crucial in the design and selection of agricultural machinery. The determination of SPR in the laboratory is complex and time-consuming, while measuring SPR on-site shows high uncertainty at different times and locations due to soil heterogeneity. Therefore, this paper investigated the impact of soil parameters on SPR for paddy soils in the plastic state and then established a simple regression model to predict SPR using easy-to-obtain soil physical properties, including clay content, water content and density. Using the combined approaches of central composition rotatable design (CCRD) with response surface methodology (RSM), SPR of 20 soil samples from five paddy fields were measured in the laboratory. The results from the experiments showed that the contribution rate of each single factor to SPR from high to low was soil density, clay content and water content. Statistical analysis for the established equation suggested that the p-value for goodness of fit was significant (p < 0.001) and the p-value for lack of fit was insignificant (p > 0.05); meanwhile, the coefficient of determination (R2) was 0.95, indicating that the model was effective in predicting the SPR. Subsequently, the performance of the regression model was validated by comparing the estimated SPR with in situ field measurements, which showed high accuracy, with percent errors within 10%. Our study successfully proposed a method to estimate SPR using easy-to-measure soil properties that could be obtained from sensors in the soil or field investigations, including soil clay content, water content and wet bulk density.
29 May 2025 in Journal of Environmental Management
High-performance fertilization equipment with high uniformity is essential for the improvement of fertilizer use efficiency in paddies. The performance of these fertigation systems might be affected by the initial field conditions and fertilizer doses. In this study, the uniformity of fertilization by an automatic system (SF) was investigated; the investigation had two initial field water conditions and fertilizer doses, and manual fertilization by farmers (FF) was used as the control. After fertilization, the Christiansen uniformity coefficient (CU) in the SF paddies was higher than in the FF paddies, and the SF in the non-flooded paddies (SFN) was the highest. With time, the CU of treatments with poor fertilization uniformity was improved; it was driven by the osmotic potential of fertilizer ions, but it was far from exceeding that of the treatments originally conducted with higher CU. For the SF treatments, the fertilizer dose did not affect fertilization uniformity significantly; so, an SF can match the efficient fertilization strategies more precisely. As water-saving irrigation (WSI) is conducive to the production of non-flooded field conditions and the promotion of the efficient use of topdressing, the use of automatic fertilization systems to implement efficient fertilization management practices in WSI paddy fields is suggested.