Acrylamide-based, thermoresponsive core–shell microgels with a linear phase transition region are used as improved carriers for catalytically active silver nanoparticles in the present study. In this context, we investigated the swelling behavior of the carriers and the stability of the silver nanoparticles inside the polymer network with photon correlation spectroscopy, transmission electron microscopy, and by following the surface plasmon resonance of the nanoparticles. Depending on the cross-linker content of the microgel core, we observed very good stability of the nanoparticles inside the microgel network, with nearly no bleeding or aggregation of the nanoparticles over several weeks for core cross-linker contents of 5 and 10 mol %. The architecture of the hybrid particles in the swollen state was investigated with cryogenic transmission electron microscopy. The particles exhibit a core–shell structure, with the silver nanoparticles located mainly at the interface between the core and shell. This architecture was not used before and seems to grant advanced stability to the nanoparticles inside the network in combination with good switchability of the catalytic activity. This was measured by following the reduction of 4-nitrophenole, which is a well-studied model reaction. The obtained Arrhenius plots show that similar to previous works, the swelling of the core and shell can influence the catalytic activity of the silver nanoparticles. As mentioned before, the cross-linker content of the core seems to be a very important parameter for the switchability of the catalytic activity. A higher cross-linker content of the core seems to be connected to a stronger influence of the carrier swelling degree on the catalytic activity of the silver nanoparticles.

This work investigates the temperature-dependent micelle formation as well as the micellar structure of the saponin aescin. The critical micelle concentration ( $cmc$ ) of aescin is determined from the concentration-dependent autofluorescence (AF) of aescin. Values between $cm{c}_{\mathrm{aescin},\mathrm{AF}}$ (10 ${}^{\circ }$ C) = 0.38 ± 0.09 mM and $cm{c}_{\mathrm{aescin},\mathrm{AF}}$ (50 ${}^{\circ }$ C) = 0.32 ± 0.13 mM were obtained. The significance of this method is verified by tensiometry measurements. The value determined from this method is within the experimental error identical with values obtained from autofluorescence ( $cm{c}_{\mathrm{aescin},\mathrm{T}\left(\mathrm{WP}\right)}$ (23 ${}^{\circ }$ C) = 0.33 ± 0.02 mM). The structure of the aescin micelles was investigated by small-angle X-ray scattering (SAXS) at 10 and 40 ${}^{\circ }$ C. At low temperature, the aescin micelles are rod-like, whereas at high temperature the structure is ellipsoidal. The radii of gyration were determined to ≈31 Å (rods) and ≈21 Å (ellipsoid). The rod-like shape of the aescin micelles at low temperature was confirmed by transmission electron microscopy (TEM). All investigations were performed at a constant pH of 7.4, because the acidic aescin has the ability to lower the pH value in aqueous solution.

Mild reaction conditions are highly desirable for bio‐orthogonal side chain derivatizations of amino acids, peptides or proteins due to the sensitivity of these substrates. Transition metal catalysed cross‐couplings such as Suzuki–Miyaura reactions are highly versatile, but usually require unfavourable reaction conditions, in particular, when applied with aryl bromides. Ligand‐free solvent‐stabilised Pd‐nanoparticles represent an efficient and sustainable alternative to conventional phosphine‐based catalysts, because the cross‐coupling can be performed at considerably lower temperature. We report on the application of such a highly reactive heterogeneous catalyst for the Suzuki–Miyaura cross‐coupling of brominated tryptophan derivatives. The solvent‐stabilised Pd‐nanoparticles are even more efficient than the literature‐known ADHP‐Pd precatalyst. Interestingly, the latter also leads to the formation of quasi‐homogeneous Pd‐nanoparticles as the catalytic species. One advantage of our approach is the compatibility with aqueous and aerobic conditions at near‐ambient temperatures and short reaction times of only 2 h. The influence of different N^α‐protecting groups, boronic acids as well as the impact of different amino acid side chains in bromotryptophan‐containing peptides has been studied. Notably, a surprising acceleration of the catalysis was observed when palladium‐coordinating side chains were present in proximal positions.

Recombinant adeno-associated viruses (rAAV) provide outstanding options for customization and superior capabilities for gene therapy. To access their full potential, facile genetic manipulation is pivotal, including capsid loop modifications. Therefore, we assessed capsid tolerance to modifications of the structural VP proteins in terms of stability and plasticity. Flexible glycine-serine linkers of increasing sizes were, at the genetic level, introduced into the 587 loop region of the VP proteins of serotype 2, the best studied AAV representative. Analyses of biological function and thermal stability with respect to genome release of viral particles revealed structural plasticity. In addition, insertion of the 29 kDa enzyme β-lactamase into the loop region was tested with a complete or a mosaic modification setting. For the mosaic approach, investigation of VP2 trans expression revealed that a Kozak sequence was required to prevent leaky scanning. Surprisingly, even the full capsid modification with β-lactamase allowed for the assembly of capsids with a concomitant increase in size. Enzyme activity assays revealed lactamase functionality for both rAAV variants, which demonstrates the structural robustness of this platform technology.