In addition to their role in skull growth, sutures are sites of flexibility between the more rigid bones. Depending on the suture, predominant loading during life may be either tensile or compressive. Loads are transmitted across sutures via collagenous fibers and a fluid-rich extracellular matrix and can be quasi-static (growth of neighboring tissues) or intermittent (mastication). The mechanical properties of sutures, while always viscoelastic, are therefore quite different for tensile versus compressive loading. The morphology of individual sutures reflects the nature of local loading, evidently by a process of developmental adaptation. In vivo or ex vivo, sutural cells respond to tensile or cyclic loading by expressing markers of proliferation and differentiation, whereas compressive loading appears to favor osteogenesis. Braincase and facial sutures exhibit similar mechanical behavior and reactions despite their different natural environments.
1 December 2001 in Comparative Biochemistry and Physiology Part A: Molecular & Integrative Physiology
Endochondral ossification at the caudal junctions of the cartilaginous nasal septum, in combination with interstitial expansion of the septum, is thought to displace the facial skeleton away from the neurocranium. However, the rate of endochondral ossification has not been measured or related to rates of septal enlargement. This study examined endochondral ossification at these junctions in mice from postnatal days 0–15, in the context of known cranial growth sites, the synchondroses. BrdU labeling was used to compare cell division at the septoethmoidal and septopresphenoidal junctions with cell division at the synchondroses, and double‐fluorochrome labeling was used to measure mineralization rate. The results showed that the septoethmoidal and septopresphenoidal junctions develop the characteristic morphology of growth plates postnatally, and that the pattern of cell division is similar to that of synchondroses. Mineralization at these junctions occurred at rates that were not statistically different from those of the synchondroses. However, the cartilaginous septum increased in length much more rapidly than could be explained by caudal growth, implying that interstitial expansion is the more important contributor to septal growth. Anat Rec Part A, 288A:1163–1172, 2006.
‘Loading of the TMJ’ is usually understood to mean a compressive force applied to the articular surfaces of the jaw joint. Theoretical models of jaw mechanics can be manipulated to support either the presence or the absence of loading, depending on the assumed contraction patterns of the muscles and the assumed occlusion. This paper synthesizes a series of studies on jaw joint function using pigs as substitutes for humans. Bone strain (deformation) was directly measured on the lateral surfaces of the condylar neck and the squamosal (equivalent to the human temporal) bone. Chewing strains indicate that loading does occur and is not light. The peak strains on the condyle are indeed primarily compressive, but the situation is dynamic. Small tensile strains can occur during chewing, and protrusive splints may decrease the strain resulting from muscle stimulation. The squamosal bone is even more surprising, in that the major strain is tensile. The most likely explanation for this finding is that the squamosal bone is bent under the load. Thus, the two elements of the TMJ are deformed in different ways by the same movements and muscle activities. Internal bony architecture reflects these differences. The condyle is filled with fine, vertically oriented bony trabeculae. The articular eminence has thick cortices and trabeculae oriented approximately transversely. In conclusion, the TMJ is loaded, but the situation is complex. The largest forces seen by the condyle are compressive, and they arise from muscle contraction. These same forces serve to bend the squamosal bone.