The development of superconducting electronics based on nanocryotrons has been limited so far to few device circuits, in part due to the lack of standard and robust logic cells. Here, we introduce and experimentally demonstrate designs for a set of nanocryotron-based building blocks that can be configured and combined to implement memory and logic functions. The devices were fabricated by patterning a single superconducting layer of niobium nitride and measured in liquid helium on a wide range of operating points. The tests show bit error rates with above margins up to and the possibility of operating under the effect of an out-of-plane magnetic field, with margins at . Additionally, we designed and measured an equivalent delay-flip-flop made of two memory cells to show the possibility of combining multiple building blocks to make larger circuits. These blocks may constitute a solid foundation for the development of nanocryotron logic circuits and finite-state machines with potential applications in the integrated processing and control of superconducting nanowire single-photon detectors.
We present a design for a superconducting nanowire binary shift register, which stores digital states in the form of circulating supercurrents in high-kinetic-inductance loops. Adjacent superconducting loops are connected with nanocryotrons, three-terminal electrothermal switches, and fed with an alternating two-phase clock to synchronously transfer the digital state between the loops. A two-loop serial-input shift register was fabricated with thin-film NbN and a bit error rate of less than 10−4 was achieved, when operated at a maximum clock frequency of and in an out-of-plane magnetic field of up to . A shift register based on this technology offers an integrated solution for low-power readout of superconducting nanowire single photon detector arrays and is capable of interfacing directly with room-temperature electronics and operating unshielded in high magnetic field environments.
Improving the scalability, reproducibility, and operating temperature of superconducting nanowire single photon detectors (SNSPDs) has been a major research goal since the devices were first proposed. The recent innovation of helium-ion irradiation as a post-processing technique for SNSPDs could enable high detection efficiencies to be more easily reproducible, but is still poorly understood. Additionally, fabricating detectors at micron-wide scales from high-T $_{\mathrm{C}}$ materials could improve scalability and operating temperature, respectively. At the same time, fabrication of successful devices in wide wires and from higher-T $_{\mathrm{C}}$ materials like magnesium diboride has proven challenging. In this work, we compare helium ion irradiation in niobium nitride and magnesium diboride detectors with different material stacks in order to better understand the mechanics of irradiation and practical implications of encapsulating layers on effective dose. We examine the effects of experimental effective dose tests and compare these results to the damage per ion predicted by simulations in corresponding material stacks. In both materials, irradiation results in an increase in count rate, though for niobium nitride this increase has not fully saturated even at the highest tested dose of $2.6\times 10^{17}$ ions/cm $^{2}$ , while for resist-encapsulated magnesium diboride even the lowest tested dose of $1\times 10^{15}$ ions/cm $^{2}$ appears higher than optimal. Our results demonstrate the general applicability of helium ion irradiation to vastly different devices and material stacks, albeit with differing optimal doses, and show the reproducibility and effectiveness of this post-processing technique in significantly improving SNSPD efficiency.