The chemical analysis of hop-derived humulone and isohumulone components in hops and beer was investigated using multiple injections in a single experimental run (MISER) extracted ion LC-MS. Comparative analysis of the humulone and lupulone contents of 12 hop varieties was accomplished in a 12 min run, an equivalent time of 1 min per hop sample. Rapid analysis of a group of 70 different beers in 74 min provided a comparative assessment of the amount of humulones (α-acids) and the isomerized isohumulones (iso-α-acids) present, also in an equivalent time of 1 min per sample. The relative humulone/isohumulone content was evaluated in a scatter plot, which allowed profiling of various craft and commercial beer styles. The MISER LC-MS approach allows for high-throughput analysis and a significant time savings. Together, these provide opportunities for increasing analysis sampling in production or a simple, rapid chemical analysis to accompany educational or classroom instruction.
Deuterated isohumulones can be prepared directly from humulones by an acyloin ring contraction under either magnesium-catalyzed basic conditions or by photochemical-induced reactions in deuterated solvents. Reactions of humulones with biphasic methylene chloride/aqueous NaOD and MgSO4 in D2O leads to stereoselective formation of cis-d 3-isohumulones (cis/trans ratio of 82:18) as the magnesium salts in yields of 71–83%. Greater than 95% incorporation of three deuterons is observed at the C5 position of the pentenone ring and the methylene position of the C4 acyl group. Photochemical isomerization with a 400 nm blue LED source enables stereospecific formation of deuterated trans-isohumulones in 36–82% yield with greater than 95% incorporation of deuterium at the C5 ring position. Oxidation of humulones with cumene hydroperoxide in basic D2O gives isohumulinones with partial 55–73% incorporation of deuterium due to keto–enol isomerization of the methylene substituent of the C4 acyl group. The structural identities of the deuterated products are determined by a combination of negative-mode electrospray mass spectrometry (MS-ESI–) and 2D heteronuclear proton–carbon HMQC NMR analysis.
Acrylohydroxamic acid, which is a useful monomer for the preparation of polymeric materials, has been prepared in a straightforward, two-step synthesis from readily available starting materials. The key steps are coupling of acrylic acid with O-tetrahydropyranylhydroxyl amine to provide protection of the hydroxylamine functionality, followed by acid cleavage of the protecting group.
Humulones are a family of homolog natural products obtained from the strobiles of humulus lupulus, or hops plants. Structurally, they consist of substituted phloroglucinols with two isoprenyl side chains, a carbonyl group and a quaternary ring carbon substituted with a hydroxyl group. The three most prominent homologs are n-, co- and ad-humulone, containing isobutyl, isopropyl and secbutyl ketone groups, respectively. When solutions of humulones are exposed to UV light, they undergo stereoselective isomerization to the five-membered ring trans-isohumulones. A photoreactor was assembled from strip LEDs in close contact with UV-transparent tubing. This reactor allowed continuous-flow chemical synthesis of the isohumulones. The yield, conversion and product throughput are compared for the humulones, using LEDs emitting white, blue and ultraviolet light (visible, 400 nm, and 365 nm, respectively). Using an optimized continuous-flow reactor, a throughput of 0.43 g/h was obtained for trans-n-isohumulone.