This paper presents an integrated navigation system for underwater vehicles to improve the performance of a conventional inertial acoustic navigation system by introducing range measurement. The integrated navigation system is based on a strapdown inertial navigation system (SDINS) accompanying range sensor, Doppler velocity log (DVL), magnetic compass, and depth sensor. Two measurement models of the range sensor are derived and augmented to the inertial acoustic navigation system, respectively. A multirate extended Kalman filter (EKF) is adopted to propagate the error covariance with the inertial sensors, where the filter updates the measurement errors and the error covariance and corrects the system states when the external measurements are available. This paper demonstrates the improvement on the robustness and convergence of the integrated navigation system with range aiding (RA). This paper used experimental data obtained from a rotating arm test with a fish model to simulate the navigational performance. Strong points of the navigation system are the elimination of initial position errors and the robustness on the dropout of acoustic signals. The convergence speed and conditions of the initial error removal are examined with Monte Carlo simulation. In addition, numerical simulations are conducted with the six-degrees-of-freedom (6-DOF) equations of motion of an autonomous underwater vehicle (AUV) in a boustrophedon survey mode to illustrate the effectiveness of the integrated navigation system.

Cadmium sulfide (CdS) thin films with n-type semiconductor characteristics were prepared at room temperature on glass substrates by radio-frequency magnetron sputtering for photoconductive-sensor applications. Films deposited at room temperature exhibit polycrystalline phases and show smooth surface morphologies. The deposition rate of the films decreases with increasing working pressure. The dark- and photoresistances in 400-nm-thick CdS films deposited at 6.7×10−1Pa and 80W were approximately 1×105 and 3×104Ω∕sq, respectively. Lowering both the dark- and photoresistances lowers the sensitivity (Rdark∕Rphoto) of the resistance.

In this paper we propose a set of techniques for a real-time motion capture of a human body. The proposed motion capture system is based on low cost accelerometers, and is capable of identifying the body configuration by extracting gravity-related terms from the sensor data. One sensor unit is composed of 3 accelerometers arranged orthogonally to each other, and is capable of identifying 2 rotating angles of joints with 2 degrees of freedom. A geometric fusion technique is applied to cope with the uncertainty of sensor data. A practical calibration technique is also proposed to handle errors in aligning the sensing axis to the coordination axis. In the case where motion acceleration is not negligible compared with gravity acceleration, a compensation technique to extract gravity acceleration from the sensor data is proposed. Experimental results not only for individual techniques but also for human motion capturing with graphics are included.