This paper discusses the vibration-induced error in non-ideal MEMS tuning fork gyroscopes (TFGs). Ideal TFGs which are thought to be immune to vibrations do not exist, and imbalance between two gyros of TFGs is an inevitable phenomenon. Three types of fabrication imperfections (i.e., stiffness imbalance, mass imbalance, and damping imbalance) are studied, considering different imbalance radios. We focus on the coupling types of two gyros of TFGs in both drive and sense directions, and the vibration sensitivities of four TFG designs with imbalance are simulated and compared. It is found that non-ideal TFGs with two gyros coupled both in drive and sense directions (type CC TFGs) are the most insensitive to vibrations with frequencies close to the TFG operating frequencies. However, sense-axis vibrations with in-phase resonant frequencies of a coupled gyros system result in severe error outputs to TFGs with two gyros coupled in the sense direction, which is mainly attributed to the sense capacitance nonlinearity. With increasing stiffness coupled ratio of the coupled gyros system, the sensitivity to vibrations with operating frequencies is cut down, yet sensitivity to vibrations with in-phase frequencies is amplified.
The nonuniformity caused by fluctuations of indium composition, thickness and doping concentration of epitaxial absorption layer of InGaAs focal plane arrays (FPAs) is estimated theoretically with the incorporation of practical status. By the measurements on epitaxy wafers of 2 in. size, the fluctuation of indium composition is observed to be less than ±0.2% and ±1% for lattice matched In0.53Ga0.47As and wavelength extended In0.80Ga0.20As photodetector structures respectively, while the thickness and doping fluctuations are assumed to be the same. Results show that the response nonuniformity caused by fluctuation of indium composition is dependent on the target wavelength and can be neglected with a minor composition fluctuation if the cutoff wavelength is well set. The total response nonuniformity induced by the effects of thickness and doping fluctuations, which dominates the FPA performance for large signal applications, is estimated to be less than ±0.1% and ±0.5% for In0.53Ga0.47As and In0.80Ga0.20As FPAs smaller than 1 in. in maximum side length. Neglecting the effects of defects, the total detectivity nonuniformity caused by these fluctuations is about ±2% for In0.53Ga0.47As FPA and will reach up to about ±19% for In0.80Ga0.20As FPA, where the dark current nonuniformity due to the fluctuation of composition plays the most critical role.
Under the wake of COVID-19, agricultural production and people's consumption are seriously affected, in addition, the number of methods to quantitatively analyze of the degree of influence is limited. The big data of electrical power can accurately reflect the business situation of enterprises in the industry. This paper select hundreds of leading enterprises in agricultural industrialization as the analysis objects, and use Keyword Index Technology to construct the corresponding system of enterprise name-electric household number, and use Multilevel Coordination Algorithm to fit the electricity curve of leading enterprises in agricultural industrialization, to study the impact degree difference and resilience of the epidemic situation on the subdivision industry, and use Covariance Analysis Algorithm to analyze the correlation of subdivision industry under the epidemic situation, and to give the prospect of development opportunities in the period after the COVID-19 epidemic situation.