Composite adsorbents based on a natural biopolymer matrix of chitosan, to which 4-amino-N′-hydroxy-1,2,5-oxadiazole-3-carboximidamide and its Se derivative were attached, were synthesized. A complex of physicochemical analysis methods indicates that the direct introduction of a matrix with high ionic permeability into the reaction mixture contributes to the formation of homogeneous particles of composite with developed surface morphology, which enhances the kinetic and capacitive parameters of uranium sorption in liquid media. It has been established that the direct introduction of a matrix with high ionic permeability into the reaction mixture contributes to the formation of homogeneous particles with a developed surface morphology, which enhances the kinetic and capacitive parameters of uranium sorption in liquid media. The synthesized materials had increased sorption-selective properties towards uranium in the pH range from 4 to 9 under static sorption conditions. The formation of the Se derivative of amidoxime during its attachment to the polymer matrix (Se-chit) contributes to the creation of a more chemically stable and highly effective adsorbent, compared to the direct binding of 4-amino-N′-hydroxy-1,2,5-oxadiazole-3-carboximidamide with chitosan (43AF-chit). The optimal parameters for the synthesis of materials were established. It was demonstrated that the ratio of amidoxime to chitosan should be within the range of 2:1 to 1:2. As the mass content of chitosan increases, the material gradually dissolves and transforms into a gel, resulting in the formation of liquid radioactive waste with a complex chemical composition. It was found that the kinetic sorption parameters of composite materials increase 2–10 times compared to those of non-composite materials. The sorption capacity of uranium in solutions with pH 6 and pH 8 can reach approximately 400–450 mg g⁻¹. Under dynamic sorption conditions, the effective filtration cycle values (before uranium slips into the filtrate ≥ 50%) improve significantly when transitioning from a non-composite adsorbent to a composite one: increasing from 50 to 800 b.v. for pH 6 and from 2700 to 4000 b.v. for pH 8. These results indicate that the synthesized sorbents are promising materials for uranium removal from liquid media, suitable for both purification and the recovery of radionuclides as valuable raw materials.

During the 71st cruise of the R/V Akademik Oparin in the summer of 2024, we assessed the distributions of dissolved and particulate forms of ²¹⁰Pb and ²¹⁰Po in the Sea of Japan, the Sea of Okhotsk, and the northwestern Pacific Ocean. Quantitative estimates of vertical fluxes were derived based on measured concentrations of suspended particulate matter (SPM) and particulate organic carbon (POC). This study provides the first in situ measurements of these radionuclides and the first estimates of derived fluxes for the Sea of Okhotsk. The study confirmed the existence of two contrasting biogeochemical regimes: a sedimentation regime in the productive waters of the Sea of Okhotsk and a recycling regime in the oligotrophic waters of the open ocean, separated by the dynamic transition zone of the Kuril Islands. The calculated POC fluxes confirmed the high efficiency of the biological pump in the coastal seas. The identified anomalies in the distribution of radionuclides indicate a significant role of lateral transport and the sorption of organic carbon onto mineral particles in shaping vertical fluxes matter.

The article presents a comprehensive comparative performance evaluation and validation of composite adsorbents based on the Se-derivative of 4-amino-N′-hydroxy-1,2,5-oxadiazole-3-carboximidamide for U (VI) recovery from complex multicomponent aqueous media. Our results indicate the composite materials to be comparable to, and in some cases to surpass, existing adsorbents in recovery efficiency. Under static sorption conditions for trace U (VI) from real multicomponent solutions (tap, river, and sea water), the sorption efficiency reached 80–98%, while the distribution coefficients ranged from 10⁴ to 10⁶ cm³ g⁻¹. The sorption-selectivity properties of the materials were evaluated in the presence of competing ions (EDTA and oxalate ions), which possess a high chelating capacity and a strong tendency to form complexes with uranium. The dependence of sorption efficiency on the concentration of these ions and the solution pH was investigated. The possibility of reusing the materials over multiple sorption-desorption cycles was assessed. An optimal regenerating eluent agent was identified (NaHCO₃/NH₄NO₃), providing a desorption efficiency of >95% without degrading the material’s sorption properties over repeated cycles. Using a combination of physicochemical methods, including sorption techniques, the mechanism of uranium sorption and its dependence on the material structure were determined. The efficiency of uranium recovery from multicomponent natural waters was also investigated under dynamic conditions over repeated sorption-desorption cycles. The results demonstrate through comparative analysis that the developed composites exhibit a high sorption capacity and possess a high practical potential for the concentration and recovery of uranium from high-salinity solutions with complex composition.