While metal is the most common conductive constituent element in the preparation of metamaterials, one-dimensional conductive carbon nanotubes (CNTs) provide alternative building blocks. Here alumina (Al₂O₃) nanocomposites with multi-walled carbon nanotubes (MWCNTs) uniformly dispersed in the alumina matrix were prepared by hot-pressing sintering. As the MWCNT content increased, the formed conductive MWCNT networks led to the occurrence of the percolation phenomenon and a change of the conductive mechanism. Two different types of negative permittivity (i.e., resonance-induced and plasma-like) were observed in the composites. The resonance-induced negative permittivity behavior in the composite with a low nanotube content was ascribed to the induced electric dipole generated from the isolated MWCNTs. The frequency dispersions of such negative permittivity can be fitted well by the Lorentz model, while the observed plasma-like negative permittivity behavior in the composites with MWCNT content exceeding the percolation threshold could be well explained by the low frequency plasmonic state generated from conductive nanotube networks using the Drude model. This work is favorable to revealing the generation mechanism of negative permittivity behavior and will greatly facilitate the practical applications of metamaterials.

Porous ceramics have been widely used in heat insulation, filtration, and as a catalyst carrier. Ceramics with high porosity and high strength are desired; however, this high porosity commonly results in low strength materials. In this study, porous alumina with high porosity and high strength was prepared by a popular direct foaming method based on particle-stabilized wet foam that used ammonium polyacrylate (PAA) and dodecyl trimethyl ammonium chloride (DTAC) as the dispersant and hydrophobic modifier, respectively. The effects of the dispersant and surfactant contents on the rheological properties of alumina slurries, stability of wet foams, and microstructure and mechanical properties of sintered ceramics were investigated. The microstructure of porous ceramics was regulated using wet foams to achieve high strength. For a given PAA content, the wet foams exhibited increasing stability with increasing DTAC content. The most stable wet foam was successfully obtained with 0.40 wt% PAA and 0.02 wt% DTAC. The corresponding porous alumina ceramics had a porosity of 82%, an average grain size of 0.7 µm, and a compressive strength of 39 MPa. However, for a given DTAC content, the wet foams had decreasing stability with increasing PAA content. A possible mechanism to explain these results is analyzed.