The effect of swell waves on atmospheric boundary layer turbulence under low winds was explored using data from a fixed platform located in the South China Sea. The wind spectra, cospectra, and Ogive curve measured at a height of 8 m above the mean sea surface provided direct evidence that wind stress was affected by swell waves. To interpret such phenomena, an improved approach was derived based on the fact that the total wind stress was the vector sum of turbulent stress and wave‐coherent stress. Different from the approaches of earlier studies, our approach did not align the turbulent stress with the mean wind speed. The influence of swell waves on the magnitude and direction of the total wind stress was analyzed using our approach. The results showed that the wave‐coherent stress derived from our data accounted for 32% of the total wind stress. The magnitude and angle of the wind stress changed by swell waves depended on the relative angle between the turbulent stress and swell direction.
The noise control of flank array sonar is a primary approach to enhance the sonar detection range. During submarine navigation, hydrodynamic noise is the main noise source in the platform region of the flank array sonar, which includes flow noise and flow-induced noise. Therefore, an in-depth investigation of hydrodynamic noise is necessary. In this paper, we firstly take the teardrop submarine as a computational model to validate the computational method. Afterwards, we numerically simulate the flow and flow-induced noise characteristics for the cylindrical shell model, and investigate differences in noise at different detection points along the X, Y, and Z axes. Finally, experiments are conducted to confirm the accuracy of the simulation results. The research findings reveal that, at the same frequency, flow-induced noise exceeds flow noise, and the noise decreases as the distance between the walls of the cylindrical shell increases. The experimental and simulation results are consistent, suggesting that the selected computational method can precisely simulate the submarine’s noise.
Wave energy is a kind of clean energy that is rich in reserves and has not been exploited on a large scale. The slope-pendulum wave energy conversion (S-PWEC) device has been optimized in structure and its capture efficiency has been increased. Taking the selection of the Zhejiang sea area as the research background, this paper performs numerical simulation and array WEC experimental testing of S-PWEC under 66 major sea conditions. The experimental results show that S-PWEC adds a slope structure to the bottom, which can effectively improve the motion response ability and resistance to extreme sea conditions. In the regular wave and irregular wave tests, the electron power output efficiency can be increased by 13.24% and 10.06%, respectively; in the array WEC experiment, the diffraction effect and radiation effect will affect the work of the array WEC, and the optimal arrangement distance can be selected to maximize the power output of the WEC system.
Based on the wave reflection principle, a floating flapping-panel wave energy converter was developed. The feasibility study and optimization study of the new WEC was carried out by laboratory research and computational fluid dynamics techniques. A numerical model was developed for an in-depth study to establish the relationship between slope tilt angle and power. The results for different wave periods show that the power take-off damping coefficient has a significant effect on the power. Meanwhile, the effects of flap length and wave height on converter resonance and power are investigated. Finally, a preliminary laboratory physical model test of the device is conducted. The flapping-panel-slope structure is very feasible and effective with good hydrodynamic performance.
18 December 2018 in Journal of Low Frequency Noise, Vibration and Active Control
The geometrical model was built by the computer-aided design software and imported into STAR-CCM+. Typical wave conditions in the East China Sea were used in computational fluid dynamics simulation. By observing overtopping process and recording water discharge, the relationship between wave conditions and overtopping process was obtained. Finally, the simulation was validated by comparing the theoretical and experimental results. Furthermore, an empirical model was developed to predict the water discharge.