One of the alternatives to decrease the concentration of CO is its oxidation reaction to CO 2 , which can be made more efficient using catalysts. In this work, it is shown that pyrochlore structures are a promising candidate to act as heterogeneous catalysts due to their chemical and physical properties. For use as a catalyst in this reaction, the Pr 2 Zr 2−x Fe x O 7±δ ( x = 0, 0.05, 0.10, and 0.15) system was synthesized by the solvothermal method, firing the powder obtained at temperatures of 1200 and 1400°C. The diffraction patterns confirmed the pyrochlore structure as the single phase in all the nominal compositions. The Brunauer–Emmett–Teller method and dynamic light‐scattering analysis showed an increase in the particle size and a decrease in the specific surface area when increasing the iron concentration and increasing the calcination temperature. The compositions that presented the best catalytic activity were the samples with the highest iron concentration. Moreover, these samples were able to convert all the CO oxidation reactions in a narrower temperature range than a conventional CeO 2 sample. The presence of vacancies and the redox behavior of the elements present are the key factors for the catalysis of this system in the CO oxidation reaction.
In this work, a series of BaxMn0.7Cu0.3O3 samples (x: 1, 0.9, 0.8, and 0.7, BxMC) was synthesized, characterized, and used as catalysts for CO oxidation reaction. All formulations were active for CO oxidation in the tested conditions. A correlation between the electrical conductivity, obtained by impedance spectroscopy, and the reducibility of the samples, obtained by H2-TPR, was observed. The Ba0.8Mn0.7Cu0.3O3 composition (B0.8MC) showed the best catalytic performance (comparable to that of the 1% Pt/Al2O3 reference sample) during tests conducted under conditions similar to those found in the exhaust gases of current gasoline engines. The characterization data suggest the simultaneous presence of a high Mn(IV)/Mn(III) surface ratio, oxygen vacancies, and reduced copper species, these two latter being key properties for ensuring a high CO conversion percentage as both are active sites for CO oxidation. The reaction temperature and the reactant atmosphere composition seem to be the most important factors for achieving a good catalytic performance, as they strongly determine the location and stability of the reduced copper species.
In this work, the impedance spectroscopy (IS) technique was used to aid in understanding the reaction mechanism of the CO oxidation reaction using the Pr 2 Zr 2−x Fe x O 7±δ ( x = 0 and 0.10) mixed oxide as a heterogeneous catalyst. The catalytic reaction occurred in the same temperature range where there was a decrease in the overall resistivity of the materials. Moreover, it has been observed that within the temperature range where the catalytic process takes place, there is a variation in the A and n parameters of the power law dispersion. Combining IS with catalytic reactions offers a robust approach to enhance the understanding of the mechanisms involved in the CO oxidation reaction. It enables precise analysis of the changes that take place at the solid–gas interface, particularly the generation of reactive oxygen species. Furthermore, it allows examining the relationship between the presence of oxygen vacancies and defects, which directly impact the catalytic process.