A surge tank effectively reduces water hammer but experiences water level oscillations during transient processes. A double chamber surge tank is used in high head plants with appreciable variations in reservoir water levels to limit the maximum amplitudes of oscillation by increasing the volume of the surge tank near the extremes of oscillation. Thus, the volume of the chambers and the design of an orifice are the most important factors for controlling the water level oscillations in a double chamber surge tank. Further, maximum/minimum water level in the surge tank and damping of surge waves have conflicting behaviors. Hence, a robust optimization method is required to find the optimum volume of chambers and the diameter of the orifice of the double chamber surge tank. In this paper, the maximum upsurge, the maximum downsurge, and the damping of surge waves are considered as the objective functions for optimization. The worst condition of upsurge and downsurge is determined through 1-D numerical simulation of the hydropower system by using method of characteristics (MOC). Moreover, the sensitivity of dimensions of a double chamber surge tank is studied to find their impact on objective functions; finally, the optimum dimensions of the double chamber surge tank are found using non-dominated sorting genetic algorithm II (NSGA-II) to control the water level oscillations in the surge tank under transient processes. The volume of the optimized double chamber surge tank is only 44.53% of the total volume of the simple surge tank, and it serves as an effective limiter of maximum amplitudes of oscillations. This study substantiates how an optimized double chamber surge tank can be used in high head plants with appreciable variations in reservoir water levels.
In a pressurized water conveyance system, such as a hydropower system, during hydraulic transients, maximum and minimum pressures at various controlling sections are of prime concern for designing a safe and efficient surge tank. Similarly, quick damping of surge waves is also very helpful for the sound functioning of the hydro-mechanical system. Several parameters like diameter of the surge tank, diameter of the orifice, operating discharge, working head, etc., influence the maximum/minimum surge, damping of surge waves in the surge tank, and the difference of maximum pressure head at the bottom tunnel and maximum water level in the surge tank. These transient behaviors are highly conflicting in nature, especially for different diameters of orifices (DO) and diameters of surge tanks (DS). Hence, a proper optimization method is necessary to investigate the best values of DO and DS to enhance the safety and efficiency of the surge tank. In this paper, these variables are accurately determined through numerical analysis of the system by the Method of Characteristics (MOC). Furthermore, the influence on the transient behavior with changing DO and DS is investigated and finally, optimum values of DO and DS are determined using Particle Swarm Optimization (PSO) to minimize the effects of hydraulic transients on the system without compromising the stability and efficiency of the surge tank. The obtained results show significant improvements over the contemporary methods of finding DO and DS for surge tank design.
Hydraulic oscillation mainly reveals the undesirable pressure fluctuations which can cause catastrophic failure of any hydraulic system. The behavior of a hydraulic system equipped with two different pump-turbines was investigated through hydraulic oscillation analysis to demonstrate severe consequences induced in turbine operation, including S-shaped characteristics. The impedance of a pump-turbine has an essential role in the determination of the instability of the hydraulic system. The conventional way to determine the instability solely using the slope of a characteristic curve was improved, including the effect of guide vane opening in pump-turbine impedance, which consequently modified the instability expression. With this pump-turbine impedance, hydraulic oscillation analysis, including free oscillation analysis and frequency response analysis, was carried out. The free oscillation analysis entails the computation of complex natural frequencies and corresponding mode shapes of the system. These computations provided necessary information about the vulnerable position of vital hydraulic components and the scenario for self-excited oscillation. Further, the analysis illustrates the significant role of guide vane opening to prevent the system from becoming unstable. Lastly, frequency response analysis was performed for the system with an oscillating guide vane to obtain the frequency response spectrum, which revealed that the resonating frequencies are consistent with natural frequencies, and it supported free oscillation results.
1 October 2019 in IOP Conference Series: Earth and Environmental Science
The enormous amount of water resources is a boon of nature for Nepal to escalate its global status and realize the golden era of development in every possible aspect if properly utilized. However, the incompetence of Nepal in current circumstances to arrange basic requisites for harnessing its resources left the Himalayan country behind, in crisis. Meanwhile, the northern neighbouring country China has potential to render the necessary requirements through the platform of Sino Nepal co-operation which certainly yields favourable benefits for both countries and eventually transforms friendship between Kathmandu and Beijing to new horizon. This paper describes water resources of Nepal in the context of hydropower, irrigation and water supply incorporating status of Nepal and necessary technology for development. It also discusses scope, challenges and opportunities for China in Nepalese water resources, all under the platform of Sino-Nepal relationship which ultimately cultivates the co-operation.