Smart or stimuli-responsive materials are an emerging class of materials used for tissue engineering and drug delivery. A variety of stimuli (including temperature, pH, redox-state, light, and magnet fields) are being investigated for their potential to change a material’s properties, interactions, structure, and/or dimensions. The specificity of stimuli response, and ability to respond to endogenous cues inherently present in living systems provide possibilities to develop novel tissue engineering and drug delivery strategies (for example materials composed of stimuli responsive polymers that self-assemble or undergo phase transitions or morphology transformations). Herein, smart materials as controlled drug release vehicles for tissue engineering are described, highlighting their potential for the delivery of precise quantities of drugs at specific locations and times promoting the controlled repair or remodeling of tissues.
Different films were synthesized from starch or polysaccharides extracted from distillers dried grains with soluble (DDGS) in combination with different percentages of linear polyethyleneimine (PEI) hydrochloride polymer to assess the mechanical and antimicrobial properties of the resulting composites. Moreover, a simple method for the extraction of the polysaccharide content from DDGS is reported. The materials obtained were characterized by ATR-FTIR, NMR, and XPS spectroscopy, swelling capacity, and by organic elemental analysis. In particular, the stability of the film prepared with only DDGS in copper ion solutions was improved by the incorporation of PEI. 13C HRMAS NMR studies evidenced the incorporation of the PEI polymer in the new films. Moreover, the release of PEI molecules from the films was studied by 1H NMR experiments in D2O to explain the antimicrobial properties of the PEI-based films against Staphylococcus aureus, with the DDGS–10% PEI films being the most active surface. Furthermore, the incorporation of copper ions into the different films enhanced their antimicrobial activity. Additionally, the starch–10% PEI film exhibited good swelling capacity in deionized water (~1500%), which decreased with the addition of salts (~250%). Instead, the DDGS–10% PEI film showed low swelling capacity in deionized water (~80%), with this capacity increasing with the addition of salts (~250%). The mechanical properties of the films improved considerably when 3% PEI was used.
The effect of three NADESs as pectin film plasticizers was evaluated at 10%, 30%, and 50% w/w by using the casting method. Two hydrophilic (choline chloride with glycerol or citric acid) and one hydrophobic (thymol–camphor) NADESs were used as replacement for glycerol. Oxalic acid-modified chitin nanowhiskers (oCNWs) at 1% w/w were used to evaluate the effect of the NADESs on the nanofiller. The resulting films using the hydrophobic NADES were difficult to handle and prone to cracking and performed similarly to or worse than pure pectin films. As a result, they were not further evaluated. In contrast, the hydrophilic ones showed characteristics comparable to glycerol. It was found that films containing glycerol and choline chloride–glycerol NADESs showed a decrease in opacity and tensile strength and an increase in WVP, Young’s modulus, and maximum elongation. In contrast, those that contained citric acid exhibited a different behavior: opacity was less affected, and a decrease in WVP and an increase in tensile strength and Young’s modulus (at 10% and 30% plasticizer) were found. oCNWs tended to decrease WVP and increase Young’s modulus but not in a very significant way. Our findings demonstrate that NADESs can be used as plasticizers in pectin films without the need to include glycerol and that the nature of NADESs is relevant to tuning the final properties.
27 December 2023 in Journal of Drug Delivery Science and Technology