One of the most important methods for modifying semiconductors is defect engineering, but only the right quantity of defects in the right chemical environment can produce desirable results. Heat treatment processes associated with g-C3N4 are occasionally carried out in N2 atmosphere, however, the catalytic performance of g-C3N4 produced by direct condensation of only nitrogen-rich precursors in N2 atmosphere is often unsatisfactory. This is typically attributed to the introduction of numerous defects, but the actual relationship between the formation of defects and the N2 atmosphere is rarely explained, and the resulting quantity of defects is difficult to control. We propose that the melam to melem transition is restricted due to the lack of O2 during the heat treatment of the nitrogen-rich precursor of g-C3N4 in N2 atmosphere, which leads to a substantial quantity of defects in the synthesized g-C3N4. To enhance its photocatalytic property, we propose a method to reduce the quantity of defects due to calcinating in N2 atmosphere by protonating the precursor in a way that increases the polymerization of the product. The test analysis indicated that only a moderate quantity of defects that contribute to electron excitation and enhance the separation efficiency and density of photogenerated carriers were retained, and the hydrogen evolution performance of the prepared catalyst was significantly improved.
Transition-metal phosphides are promising non-noble-metal electrocatalysts for alkaline hydrogen evolution, yet further improving their performance remains challenging. In this work, a Co-doped nanoporous Fe3P self-supported electrode was fabricated by vacuum high-frequency induction and melt spinning of Fe75Co5P20 precursor alloys, followed by electrochemical dealloying. Nanoporous Fe3P prepared from Fe80P20 was used as the reference. Structural analyses show that dealloying selectively removes the α-Fe phase while preserving the Fe3P framework, resulting in a three-dimensional nanoporous architecture. XPS results further confirm successful Co incorporation and reveal that Co doping modifies the local chemical environment of Fe and P. Benefiting from the combined effects of Co incorporation and the nanoporous structure, np-Co-Fe3P exhibits significantly improved HER performance in 1.0 M KOH, requiring only 70 mV to reach 10 mA cm−2, much lower than that of np-Fe3P (199 mV). In addition, np-Co-Fe3P shows a smaller Tafel slope of 94 mV dec−1, lower charge-transfer resistance, and a larger double-layer capacitance of 109.4 mF cm−2. This work demonstrates an effective strategy for enhancing the alkaline HER performance of Fe-based phosphides through the combination of Co incorporation and dealloying-derived nanoporous architecture.