We developed a simplified theoretical model for parameters calculation of diode temperature sensors (DTS) based on Schottky diodes (SD). The current flow mechanism of the diodes considered was dominated by over-barrier thermionic emission. Qualitative correlations between basic fundamental and electrophysical parameters of such DTS were established. The expressions for ultimate high-temperature parameters of the DTS were obtained. Theoretical results obtained were approved using test samples of DTS with Schottky contact Ni/n-SiC (4H). It was shown that physical high-temperature limit of operation of such a DTS (>1250 K) exceeded the values of commercial DTS based on Si, GaAs, AlGaAs p-n junctions. And the SD-based DTS itself demonstrated significantly lower energy consumption.
1 March 2018 in Journal of Vacuum Science & Technology B
The authors have established the factors defining the maximum temperature limit of operating as well as the thermal sensitivity of the diode temperature sensors based on double heterostructures InGaN/AlGaN in a condition when tunnel current flow prevails. The authors have obtained analytic dependencies for the maximum temperature and sensitivity and have analyzed a connection of these characteristics with the parameters of the semiconductor material and the diode structure. In particular, it was shown that the sensitivity did not depend on the diode sensor operation current and, in the case of double heterostructure, its value was proportional to the energy gap difference of the heterojunction. Relying on the experimental data, the authors state that to design a diode temperature sensor possessing maximum values of operation temperature and thermal sensitivity at minimal operation current, it is necessary to utilize double heterostructures based on wide bandgap semiconductors. Base and emitter layers of the structure should be heavily doped. The optimal value of the energy gap difference between active and confining layers of about 0.2–0.3 eV should be provided. In addition, in the double heterostructure chosen, the tunnel transport of the charge carriers with smaller effective mass should dominate.
A simple method of Eg(T) dependence determination for active areas of semiconductor devices based on wide bandgap semiconductors has been proposed and developed. Verification of the method has been carried out while determining Eg(T) dependence in a base area of p+-n-type GaP diodes in the temperature range 77–523 K. The method is based on U-T characterization of the diodes and calculation of Eg(T) dependence according to the expression obtained within present study. Satisfactory agreement between experimental and theoretical results has been achieved including references available on gallium phosphide. The method proposed could be applied to experimental data processing in high-temperature thermometry.
A new technique of liquid phase epitaxy has been proposed in this work. It allows to eliminate known disadvantages of liquid phase epitaxy by creating short-time contact between a substrate and a solution-melt, as well as due to segmental deposition of an epitaxial layer over the working substrate surface. The short-time of the contact is achieved by the means of Ampere force acting on the solution-melt. And the contact itself between the substrate and the solution-melt is realized pointwise (or segmentally) over the substrate surface using the scanning principle. The new technique was named “scanning liquid phase epitaxy”. One of the modifications of device realization of the technique proposed has been considered and its principle of operation has been described. Preliminary theoretical investigations and experimental processes of semiconductor epitaxial layers obtaining have proved principal operational capability of the new technique. The technique developed allows to obtain thin and ultrathin epitaxial layers on the substrates of very large area which is limited only by the growth equipment size.