In this work, Ni–Al-hydrotalcite-derived catalyst modified with Fe or Mg for CO2 methanation was investigated in an attempt to improve the reaction activity at low temperature. Through the characterization of XRD, H2-TPR, and N2-BET, 0.05Fe–Ni–Al2O3-HT catalyst can be found with a better reducing property, higher surface area, better Ni dispersion, and smaller pore size. The CO2 conversion using this catalyst was tested in a fixed-bed reactor in laboratory. The result showed better reaction activity at low temperature. At 219 °C, the CO2 conversion could reach 80.8 %. Meanwhile, the highest CO2 conversion of 96.0 % was achieved at 350 °C.
Mn-Na2WO4-based catalysts with different supports were prepared using the incipient wetness impregnation method and evaluated for their oxidative coupling of methane (OCM) reaction performance. The results demonstrated that the SiO2- supported catalyst exhibited the best catalytic performance, and the introduction of H2O further enhanced its activity. Under the conditions of a feed gas mixture of CH4/O2/H2O = 6:1:24 at 800 °C and atmospheric pressure, the CH4 conversion and C2+ selectivity over the Mn-Na2WO4/SiO2 catalyst increased from 28.4% and 77.4% (without H2O) to 33.2% and 84.9%, respectively. In contrast, the catalytic activity using TiO2 and MgO supports drastically declined. Characterizations using X-ray diffraction (XRD), in situ infrared spectroscopy (In-situ IR), X-ray photoelectron spectroscopy (XPS), hydrogen temperature-programmed reduction (H2-TPR), and oxygen temperature-programmed desorption (O2-TPD) revealed that the introduction of steam not only served as a diluent to decrease the partial pressures of the reactants CH4 and O2, thereby reducing deep oxidation reactions in the gas phase, but also interacted with surface oxygen species (O22-) and silica to form adjacent surface-bonded disilanol free radicals Si-OIH. This interaction facilitated the dehydrogenation and coupling of two methane molecules on the catalyst surface, resulting in the generation of C2+ products, significantly enhancing the catalytic activity and selectivity of OCM.
Converting CO2 and green hydrogen into products such as methane and methanol not only has a negative carbon effect, but also stores renewable energy into energy chemicals. This represents a promising route for hydrogen energy storage technologies. The hydrogenation of CO2 to methane and methanol, which represent strongly exothermic reactions, are thermodynamically favored at low temperatures. However, the inherent inertness of CO2 makes it difficult to activate CO2 at low temperatures. Both reactions face the challenge of activating CO2 at low temperature, so catalysts exhibiting high activity under such conditions are a critical need. Layered double hydroxides (LDHs) have attracted considerable interest owing to their regular layered structure and uniform dispersion of multiple metallic components. However, there are few studies on the same effects of promoters over LDHs-derived catalysts. Here, we investigated the same effects of promoters on two LDHs-derived catalysts in different CO2 hydrogenation reactions to illustrate the effects of promoters on facilitating low-temperature CO2 activation in LDHs-derived catalysts. By adding promoters Fe and Mn to the catalysts NiAl-Fe and CuZnAl-Mn, the crystal lattices were expanded, surface areas were increased 38% and 25%, and the reduction temperatures were decreased to 97 °C and 10 °C, respectively. These promoters significantly enhanced the CO2 adsorption and activation of the catalysts NiAl-Fe and CuZnAl-Mn. The methanation catalyst NiAl-Fe achieved a CO2 conversion of 80.8% at 200 °C and 2 MPa, while the methanol synthesis catalyst CuZnAl-Mn exhibited a CO2 conversion of 21.3% and a methanol selectivity of 61.8% under the conditions of 250 °C and 3 MPa. The influence of the LDHs precursors’ structure and the addition of promoters Fe and Mn on the catalytic performance were studied by XRD, N2 adsorption–desorption, H2-TPR, H2-TPD, and CO2-TPD.