Pyrolusite leaching slag is a Fe-containing slag generated from pyrolusite leaching process with SO2. Recovery of iron from the slag not only has economic benefit, but also prevents the secondary pollution to the environment. A novel lab-scale cyclic process for recovering iron from pyrolusite leaching slag was introduced. The process contains two steps: (1) iron was leached with oxalic acid and [Fe(C2O4)n](3−2n)+ solution was generated; (2) the [Fe(C2O4)n](3−2n)+ solution was irradiated by ultraviolet and ferrous oxalate precipitation were obtained. The effect of operation parameter on leaching and irradiation process were studied separately. In the leaching process, the optimal solid/liquid ratio, oxalic acid concentration, leaching temperature, stirring rate, and leaching time are 1:50, 0.40 mol/L, 95 °C, 300 r/min, and 3 h, respectively. In the irradiation process, the best irradiation wavelength, Fe/oxalic acid molar ratio and irradiation time are 254 nm, 1:4, and 30 min. Besides, a test of 9 continuous cycles was carried out and the performance and material balance of the combined process were investigated. The results showed that the cyclic process is entirely feasible and prove to be stable producing, and ferrous oxalate of 99.32% purity. Material balance indicated that 95.17% of iron was recovered in the form of FeC2O4·2H2O, and the recovery efficiency of oxalic acid was 58.52%.
This study investigated the potential use of pyrolusite reductive leaching residue (PLR), a low-cost residual solid by-product in manganese hydrometallurgy, as alternative adsorbent for removal of Congo red (CR) from aqueous solution. The surface characteristics of the PLR were measured. The effect of contact time was experimentally studied to evaluate the adsorption capacity, kinetics, and equilibrium. Experimental results revealed that the adsorption process almost finished within 300 min; adsorption capacity of the PLR increased with increasing initial CR concentrations and temperature. CR uptake process obeyed the pseudo-second-order kinetics. The CR uptake process was best described by the Langmuir isotherm with maximum monolayer adsorption capacity of 45.66 mg/g at 25°C. Thermodynamic studies showed CR adsorption onto the PLR was endothermic and spontaneous in nature. The regeneration studies showed that the PLR has good reuse performance. The results indicated that PLR could be employed as low-cost alternatives for removal of CR from industrial wastewater.