Textile-based wearable devices are rapidly gaining traction in the Internet of Things paradigm and offer distinct advantages for data collection and analysis across a wide variety of applications. Seamlessly integrating electronics in textiles remains a technical challenge, especially when the textiles’ essential properties, such as comfort, breathability, and flexibility, are meant to be preserved. This article investigates screen printing as a textile post-processing technique for electronic integration, and highlights its versatility, cost-effectiveness, and adaptability in terms of design and customization. The study examines two silver-based inks screen-printed on an Oxford polyester textile substrate with a focus on substrate preparation and treatment. Before printing, the textile samples were cleaned with nitrogen gas and then subjected to low-pressure oxygen plasma treatment. For comparative analysis, two samples printed on polyethylene terephthalate (PET) serve as a reference. The findings highlight the importance of plasma treatment in optimizing the printability of textiles and demonstrate that it notably improves the electrical properties of conductive inks. Despite some remaining challenges, the study indicates that screen-printed electronics show promising potential for advancing the development of e-textiles and sensor-integrated wearables.
We designed and fabricated a terahertz (THz) frequency selective surface (FSS) based on two distinct additive manufacturing technologies, namely, printable electronics (PE) and three-dimensional (3D) printing. Silver nanoparticle ink was printed on a polyethylene terephthalate (PET) substrate utilizing a large-scale roll-to-roll industrial PE technique with a flexographic printed unit, while the 3D-printed THz FSS was fabricated based on a powder bed fusion-selective laser melting system. The filtering characteristics of both types of FSS were verified through calculation, simulation, and experiments. Furthermore, the rotational tuning approach was applied to two identical FSS to form reconfigurable FSS which could be defined as Moiré FSS. Based on the numerical results obtained, our proposed technique which used a PE-based Moiré FSS achieves a 58% modulation depth at 0.25 THz, while experimental verification found a modulation depth of 41% at 0.22 THz, confirming that its adoption is simple and cost-effective. To the best of our knowledge, this is the first demonstration of a Moiré reconfigurable printed FSS operating in the THz region.
22 November 2024 in Superconductor Science and Technology
A low normal zone propagation velocity (NZPV) combined with critical current inhomogeneities favor the nucleation of destructive hot spots in rare-earth barium copper oxide (REBCO) tapes. Increasing the NZPV using the current flow diverter (CFD) concept is a promising solution to mitigate the risk of developing hot spots. The fabrication method of CFD REBCO tapes implies several steps consisting in masking, silver etching, mask removal, and silver deposition, which takes time and remains a barrier to the implementation of a low-cost industrial production of long-length CFD REBCO tapes. This work presents a cost-effective and maskless CFD fabrication approach that relies on inkjet printing (IJP) of silver patterns directly on top of the REBCO layer to create a non-uniform interfacial resistance between the silver and the REBCO surface, along the width of the tape. The parameters of IJP and oxygen annealing were optimized to obtain highly conductive silver patterns deposited on the surface of the REBCO layer. CFD REBCO tapes were successfully fabricated using commercial REBCO tapes and the proposed method without degrading the superconducting properties. Experimental measurements revealed an increase of the NZPV by a factor of 6–7 compared to commercial REBCO tapes.