Pada 2021, sektor energi Indonesia menghasilkan hampir 600 MtCO2, terutama dari industri energi pembangkitan listrik. Sektor ini menyumbang 50% dari total semua sektor yang menyumbang emisi di Indonesia. Sektor energi sangat berpeluangan sebagai sasaran dalam transisi energi dalam mengurangi emisi karbon akibat bahan bakar fosil. Penelitian ini bertujuan merencanakan Sistem Pembangkit Listrik Tenaga Surya (PLTS) On-Grid. Metode penelitian meliputi perancangan sistem PLTS On-Grid di Gedung Serba Guna Universitas Lampung dengan kapasitas 60 kWp dan simulasi menggunakan perangkat lunak PVSyst 7.4 untuk mendapatkan potensi energi berdasarkan data radiasi matahari dan suhu pada Meteonorm 8.1 dan menguji performa sistem. Hasil simulasi menunjukkan bahwa PLTS On-Grid ini mampu menghasilkan energi sebesar 88,636 MWh/tahun dengan nilai Performance Ratio sebesar 84,34%, Capacity Utilization Factor sebesar 16,85%, nilai Reference Yield tahunan mencapai 1749,8 kWh/kWp, nilai Array Yield tahunan mencapai 1504,5 kWh/kWp, dan nilai Final Yield tahunan mencapai 1475,8 kWh/kWp. Hasil ini mengindikasikan bahwa sistem PLTS yang dirancang dapat beroperasi secara efisien dalam mengkonversi energi matahari menjadi energi listrik.
1 March 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper introduces the design and hardware implementation of the dynamic evolution control for a DC/DC boost converter. The development of the controller aims to effectively regulate the output voltage of the DC/DC boost converter with a high degree of precision. A comprehensive examination of the duty cycle formula for the boost converter is conducted using a non-linear analysis approach. This study introduces a methodology for the synthesis of a converter controller utilizing the principles of dynamic evolution control theory. The converter's output consistently aligns with the target voltage by following the dynamic evolution path determined by the designed controller. The performance evaluation of the proposed boost converter controller utilizing dynamic evolution control is being validated through the utilization of MATLAB/Simulink simulation software. The effectiveness of the proposed controller is further validated through the presentation of hardware results. The performance of the controller was evaluated by varying the values of parameters k and m.
An environmentally friendly source of energy is an urgent demand. Recent advances in solar technology, especially when combined with energy storage batteries, have generated high hopes for the potential of the solar energy revolution. However, in Indonesia, the deployment of solar panels in industrial environments is limited by policies that limit the power generation allowed. Permitted rooftop solar systems in the industrial sector, under the National Electricity Company (PLN) framework, are limited to 10%-15% of the connected electricity capacity. The study focuses on assessing the level of self-consumption in industrial-scale hybrid photovoltaic (PV) systems by exploring three scenarios: maximizing self-consumption, peak shaving, and utilizing batteries exclusively at night. The findings show that when solar panel capacity accounts for only 15% of peak load demand, the ratio of own consumption to total energy demand, known as the Self-Sufficiency Rate (SSR), reaches about 5.113%. However, assuming that the load data represents only 15% of the total actual load, the SSR increases significantly to 30.157%. This variation results from energy production that is aligned with energy demand. As a result, promoting policies that facilitate optimal utilization of solar panels and batteries is recommended to achieve higher levels of self-consumption and reduce dependence on conventional energy sources.
1 March 2025 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper discusses the comprehensive design and implementation of a photovoltaic (PV) emulator hardware using a synchronous buck converter. The primary objective is to simulate the electrical characteristics of a real PV module under varying environmental conditions. The process involves detailed simulations carried out using MATLAB/Simulink software to evaluate the performance and accuracy of the emulator model. Various load values were tested to account for the impact of fluctuations in radiation and temperature. The accuracy of the emulator's output characteristics was validated by comparing them with the actual attributes of the SolarWorld Sun-module SW50 PV module. The final step involves constructing the hardware of the PV emulator using electronic components, with an Arduino Nano employed as the controller.
1 March 2026 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper presents the design, simulation, and experimental implementation of a photovoltaic (PV) emulator based on a buck converter controlled using the dynamic evolution control (DEC) technique. The proposed system accurately reproduces the nonlinear current-voltage (I-V) and power-voltage (P-V) characteristics of a commercial GREEN CELL SM100-18P (100 Wp) PV module under standard test conditions (1000 W/m2, 25 °C). The electrical characteristics of the reference module are embedded in the controller through a lookup table (LUT), which is integrated with the DEC algorithm to enable adaptive real-time regulation of output voltage and current. System modeling and validation are first conducted in MATLAB/Simulink to analyze steady-state and transient performance. A hardware prototype based on an XL4016 buck converter and Arduino Nano microcontroller is then implemented, with real-time monitoring provided via an ILI9341 TFT display. Experimental results show that the emulator achieves a maximum power deviation of 0.8%, a normalized root mean square error (RMSE) of 0.015, a settling time of approximately 12 ms, overshoot below 1.5%, voltage ripple under 2%, and peak conversion efficiency of 94% near the MPP region. These results confirm that the proposed PV emulator provides accurate static and dynamic reproduction of PV characteristics, offering a low-cost, stable, and repeatable platform for laboratory-scale evaluation of PV-related power electronic converters.