A hole flatland: When two distinct materials are placed on top of each other, the difference in polarization between the two layers can induce charge carriers at the interface. Many such two-dimensional (2D) electron gases have been observed, but engineering a 2D hole gas without the help of doping has been much trickier. Chaudhuri et al. used molecular beam epitaxy to grow a layer of gallium nitride on top of aluminum nitride without introducing dopants. This approach resulted in a high-density 2D hole gas at the interface in this technologically relevant system. Science , this issue p. 1454
5 August 2020 in IEEE Transactions on Electron Devices
Power and RF electronics applications have spurred massive investment into a range of wide and ultrawide bandgap semiconductor devices which can switch large currents and voltages rapidly with low losses. However, the end systems using these devices are often limited by the parasitics of integrating and driving these chips from the silicon complementary metal–oxide-semiconductor-based design (CMOS) circuitry necessary for complex control logic. For that reason, implementation of CMOS logic directly in the wide bandgap platform has become a way for each maturing material to compete. This review examines potential CMOS monolithic and hybrid approaches in a variety of wide bandgap materials.
In evaluating GaN HEMTs for high-power applications, it is crucial to consider the device-level breakdown characteristics. This work replaces the conventional AlGaN barrier and common AlGaN backbarrier with unstrained AlN, and it assesses the breakdown voltage of AlN/GaN/AlN quantum well HEMTs for gate-drain spacings in the range of 0.27 to 5.1 microns. Results are highlighted by a high breakdown voltage of 78 V for a gate-drain spacing of 390 nm, among the best reported for submicron-channel devices. Additionally, small-signal RF measurements showed record performance for HEMTs on the AlN platform, with ft=fmax = 161/70 GHz. Cutoff frequency and corresponding drain bias are benchmarked against stateof-the-art GaN HEMTs using the Johnson figure of merit, with measured devices highlighted by a JFoM value of 2.2 THzV. These results illustrate the potential for AlN/GaN/AlN quantum well HEMTs as a future platform for high-power RF transistors.
22 March 2021 in Semiconductor Science and Technology
Gallium nitride high-electron-mobility transistors (GaN HEMTs) are at a point of rapid growth in defense (radar, SATCOM) and commercial (5G and beyond) industries. This growth also comes at a point at which the standard GaN heterostructures remain unoptimized for maximum performance. For this reason, we propose the shift to the aluminum nitride (AlN) platform. AlN allows for smarter, highly-scaled heterostructure design that will improve the output power and thermal management of III-nitride amplifiers. Beyond improvements over the incumbent amplifier technology, AlN will allow for a level of integration previously unachievable with GaN electronics. State-of-the-art high-current p-channel FETs, mature filter technology, and advanced waveguides, all monolithically integrated with an AlN/GaN/AlN HEMT, is made possible with AlN. It is on this new AlN platform that nitride electronics may maximize their full high-power, high-speed potential for mm-wave communication and high-power logic applications.
High-performance p-channel transistors are crucial to implementing efficient complementary circuits in widebandgap electronics, but progress on such devices has lagged far behind their powerful electron-based counterparts due to the inherent challenges of manipulating holes in wide-gap semiconductors. Building on recent advances in materials growth, this work sets simultaneous records in both on-current (10 mA/mm) and on-off modulation (four orders) for the GaN/AlN widebandgap p-FET structure. A compact analytical pFET model is derived, and the results are benchmarked against the various alternatives in the literature, clarifying the heterostructure trade-offs to enable integrated wide-bandgap CMOS for nextgeneration compact high-power devices.
2 December 2020 in IEEE Journal of the Electron Devices Society
The AlN/GaN/AlN heterostructure is attractive for microwave and millimeter-wave power devices due to its thin top barrier, tight carrier confinement, and improved breakdown voltage. This work explores the large-signal RF performance of high-electron-mobility transistors on this heterostructure. Results are highlighted by record high on-current of 3.6 A/mm, and record maximum oscillation frequency (fmax) of 233 GHz. The load-pull power sweep at 10 GHz demonstrate a peak power added efficiency (PAE) of 22.7% with an associated gain (GT) of 8.7 dB and output power (Pout) of 3 W/mm. When optimized for power, the peak Pout of 3.3 W/mm has an associated PAE of 14.7% and GT of 3.2 dB. This first demonstration is encouraging for the mm-wave power potential of the AlN/GaN/AlN HEMT.