A crawler system provides much larger ground contact, leading to excellent terrain adaptability. Due to its structural characteristics, high‐frequency vibration proportional to the vehicle speed is generated during the driving process. This is a result of the polygon and rolling effects between the track and the wheels. A field test of a tracked vehicle is performed to monitor movement signals of the chassis and a rocker arm. Their corresponding power spectral density distributions confirm the correctness of the frequency‐calculation equation. Then, a novel elastic track tensioning device with a damper is designed as a cushion between the idler and the chassis. Depending on its geometry, the equivalent damping coefficient for a dynamic model is evaluated. Subsequently, the damping is altered in response to different operating conditions by a hybrid damping fuzzy semiactive control system. The controller accounts for both chassis and track vibration. Based on the transfer matrix method for multibody systems, a dynamical model of the track system is developed. Control performances are evaluated using two numerical simulations of obstacle crossing and off‐road driving operations. Results indicate that the proposed semiactive tensioner is substantially better than the conventional one. This paper provides a novel feasible scheme for vibration reduction of tracked vehicles.
The process of parametric modeling of magnetorheological (MR) damper presents difficulties such as numerous parameters, complicated and time-consuming identification procedures, and difficulty in establishing the inverse model. In order to solve these problems, this paper adopts the mind evolution algorithm backpropagation (MEA-BP) neural network to successfully establish the forward model and the inverse model for prediction of electric current. These models can accurately capture the nonlinear hysteresis characteristics of MR damper. First, the mechanical properties of the MR damper were tested, and then the BP neural network structure of the forward and inverse models was determined according to its working principle. Aiming at the problems of traditional BP neural network which is easy to mature prematurely and converge slowly, the initial weights and thresholds of BP neural network were optimized by using MEA. Utilizing the Mechanical properties test results of the MR damper, the MEA-BP neural network was used to identify the forward and inverse non-parametric models of the MR damper. Compared with the traditional BP neural network model, the forward model and inverse model of the MR damper, based on the MEA-BP neural network, showed an improvement in prediction accuracy by 33.96% and 26.32%, respectively. The forward model based on the MEA-BP neural network demonstrated a 16.67% improvement in accuracy compared to the genetic algorithm (GA) BP neural network. The non-parametric model, developed using the MEA-BP neural network, more accurately captures the dynamic behavior of the MR damper. This advancement provides a robust foundation for research into the dynamics and semi-active control of MR adaptive damping systems.
12 February 2025 in Journal of Vibration Engineering & Technologies
The occurrence of the welding heat-affected zone in Q420C steel may lead to a reduction in the toughness of the welded joint and disruption of high strength-toughness combination of Q420C. This study investigates the microstructure and mechanical properties of Q420C steel welded joints under three heat in-puts of 25 kJ/cm, 100 kJ/cm, 200 kJ/cm, and 300 kJ/cm, with high-strength matching adopted for the welded joints, Charpy impact tests at 0 °C, −20 °C, and −40 °C were conducted on the weld metal, fusion line(FL), and heat-affected zone (HAZ). The weld metal maintains high impact toughness across all tested temperatures. However, increasing the heat input leads to coarsening of the microstructure in the overheated zone of the HAZ, accompanied by the formation of ferrite. At a heat input of 300 kJ/cm, significant amounts of coarse intergranular ferrite and intragranular blocky ferrite develop in the overheated zone. These microstructural changes result in a marked reduction in the impact toughness of both the fusion zone and HAZ, and the fracture mode shifts from ductile to cleavage fracture. To ensure adequate impact toughness of Q420C welded joints, the welding heat input should be kept below 200 kJ/cm.