Titanium silicalite (TS-1) zeolites with different titanium species were synthesized and characterized by ultraviolet (UV)-Raman, ultraviolet visible (UV-Vis) diffuse reflectance spectroscopies and by the NH3 temperature programmed desorption (NH3-TPD) method. The roles of different titanium species in TS-1 samples have been investigated by gas chromatography-Raman spectrometry (GC-Raman) during the propylene epoxidation process. For the first time, a positive correlation was found among the concentration of framework Ti species, the amount of active intermediate Ti–OOH (η2) and the conversion of propylene by the in situ GC-Raman technique. The results give evidence that the framework titanium species is the active center and Ti–OOH (η2) is the active intermediate. The presence of extra-framework Ti species is harmful to propylene epoxidation. Furthermore, the amorphous Ti species has a more negative effect on the yield of propylene oxide (PO) than the anatase TiO2. The NH3-TPD results reveal that the amorphous Ti species are more acidic and thus should be mainly responsible for the further conversion of PO.
OperandoDB-FTIR and DFT results certificate that the isobutane aromatization could be exclusively catalyzed by (Zn–O–Zn)2+Lewis acid site over Zn/HZSM-5.
Iodo-Bodipy immobilized on porous silica was used as an efficient recyclable photocatalyst for photoredox catalytic tandem oxidation–[3+2] cycloaddition reactions of tetrahydroisoquinoline with N-phenylmaleimides to prepare pyrrolo[2,1-a]isoquinoline.
9 October 2008 in The Journal of Physical Chemistry C
A 3 wt% Pt catalyst supported on hierarchical porous ZSM-5 (HPZSM-5) derived from the alkali desilication of ZSM-5 with Si/Al2 ratio of 170, termed as 3Pt/HPZSM-5, was employed in the liquid-phase selective hydrogenation of cinnamaldehyde (CAL) to cinnamyl alcohol (COL). This process yielded higher CAL conversion as compared to that yielded when a conventional ZSM-5 support was used. After Sn was doped with a Pt/Sn weight ratio of 60, the 3Pt0.05Sn/HPZSM-5 catalyst was proven to be more efficient for the selective hydrogenation of CAL to COL with further improved CAL conversion, although the COL selectivity was marginally less but still comparable. As a result, both CAL conversion and COL yield over the 3Pt0.05Sn/HPZSM-5 catalyst were remarkably improved in contrast with those achieved with the Pt catalyst supported on HPZSM-5 or ZSM-5. A series of characterizations were employed to interpret the influence of alkali desilication and Sn promotion. It was revealed that the surface acidity of ZSM-5 was modified and the interaction between Pt and support became stronger, although the strong Brønsted acid sites almost vanished after partial desilication. Moreover, electron donation was observed from Sn to Pt such that the surface electronic properties of Pt nanoparticles were modulated. The surface geometry of Pt catalysts was also adjusted after Sn was doped. Based on the FT-IR spectroscopic results using CO as the probe molecule, besides Pt(111), even Pt(100) facets were exposed on the surface.