Increased intensity and frequency of floods raise concerns about the release and transport of contaminated soil and sediment to and from rivers and streams. To model these processes during flooding events, we developed an External Coupler in Python to link the Hydrologic Engineering Center‐River Analysis System (HEC‐RAS) 2D hydrodynamic model to the Water Quality Analysis Simulation Program (WASP). Accurate data transfer from a hydrodynamic model to a water quality model is critical. Our test results showed the External Coupler successfully linked HEC‐RAS and WASP and addressed technical challenges in aggregating flow data and conserving mass during the flood event. We ran the coupled models for a 100‐year flood event to calculate flood‐induced transport of sediment‐associated arsenic in Woodbridge Creek, NJ. Change in surface sediment and arsenic at the end of 48‐h flood simulation ranged from a net loss of 13.5 cm to a net gain of 11.6 cm, and 16.2 to 2.9 mg/kg, respectively, per model segment, which demonstrates the capability of the coupled model for simulating sediment and contaminant transport in flood.
In examining the dependence of the sea surface reflectance of skylight ρs on sky conditions, wind speed, solar zenith angle, and viewing geometry, Mobley [Appl. Opt. 38, 7442 (1999). [CrossRef] ] assumed ρs is independent of wavelength. Lee et al. [Opt. Express 18, 26313 (2010). [CrossRef] ] showed experimentally that ρs does vary spectrally due to the spectral difference of sky radiance coming from different directions, which was ignored in Mobley’s study. We simulated ρs from 350 nm to 1000 nm by explicitly accounting for spectral variations of skylight distribution and Fresnel reflectance. Furthermore, we separated sun glint from sky glint because of significant differences in magnitude, spectrum and polarization state between direct sun light and skylight light. The results confirm that spectral variation of ρs(λ) mainly arises from the spectral distribution of skylight and would vary from slightly blueish due to normal dispersion of the refractive index of water, to neutral and then to reddish with increasing wind speeds and decreasing solar zenith angles. Polarization moderately increases sky glint by 8 – 20% at 400 nm but only by 0 – 10% at 1000 nm. Sun glint is inherently reddish and becomes significant (>10% of sky glint) when the sun is at the zenith with moderate winds or when the sea is roughened (wind speeds > 10 m s-1) with solar zenith angles < 20°. We recommend a two-step procedure by first correcting the glint due to direct sun light, which is unpolarized, followed by removing the glint due to diffused and polarized skylight. The simulated ρs(λ) as a function of wind speeds, sun angles and aerosol concentrations for currently recommended sensor-sun geometry, i.e., zenith angle = 40° and azimuthal angle relative to the sun = 45°, is available upon request.
Non-point source (NPS) pollution from agricultural lands is the leading cause of various water quality problems across the United States. Particularly, surface depressions often alter the releasing patterns of NPS pollutants into the environment. However, most commonly-used hydrologic models may not be applicable to such depression-dominated regions. The objective of this study is to improve water quantity/quality modeling and its calibration for depression-dominated basins under wet and dry hydroclimatic conditions. Specifically, the Soil and Water Assessment Tool (SWAT) was applied for hydrologic and water quality modeling in the Red River of the North Basin (RRB). Surface depressions across the RRB were incorporated into the model by employing a surface delineation method and the impacts of depressions were evaluated for two modeling scenarios, MS1 (basic scenario) and MS2 (depression-oriented scenario). Moreover, a traditional calibration scheme (CS1) was compared to a wet-dry calibration scheme (CS2) that accounted for the effects of hydroclimatic variations on hydrologic and water quality modeling. Results indicated that the surface runoff simulation and the associated water quality modeling were improved when topographic characteristics of depressions were incorporated into the model (MS2). The Nash–Sutcliffe efficiency (NSE) coefficient indicated an average increase of 30.4% and 19.6% from CS1 to CS2 for the calibration and validation periods, respectively. Additionally, the CS2 provided acceptable simulations of water quality, with the NSE values of 0.50 and 0.74 for calibration and validation periods, respectively. These results highlight the enhanced capability of the proposed approach for simulating water quantity and quality for depression-dominated basins under the influence of varying hydroclimatic conditions.
14 June 2017 in Jawra Journal of the American Water Resources Association
The number of poly- and perfluoroalkyl substances (PFAS) and their sources, fates, and avenues of transport is vast. With every new discovery, a new question arises regarding the impact they are having on the environment. Therefore, this study aims to assess the capabilities and shortcomings of widely used models to study large-scale PFAS fate and transport. A surface water model [Soil and Water Assessment Tool (SWAT)], a groundwater model [Modular Finite-Difference Model (MODFLOW)], and a streamflow model [Water Quality Analysis Simulation Program (WASP)] were set up and integrated to simulate PFAS fate and transport in a large watershed. The study area was the Huron River watershed, a highly PFAS impacted watershed in southeastern Michigan. All of the aforementioned models were calibrated and validated for streamflow and base flow on a daily basis with Nash-Sutcliffe model efficiency coefficient (NSE) above 0.6, the ratio of the root-mean square error to the standard deviation of measured data (RSR) less than 0.6, and percent bias (PBIAS) less than . The results showed that the integrated model adequately captured the overall trends for perfluorooctane sulfonate (PFOS) but underestimated the magnitude of perfluorooctanoic acid (PFOA) concentration due to a lack of information from diffusive sources and historical loads. Therefore, it is important to organize monitoring studies and consider further model enhancements to improve our understanding of PFAS fate and transport in large watersheds.