The use of marginal-quality waters, not limited to brackish/saline and treated sewage effluent (TSE), is called reclaimed water. Reclaimed water is a sustainable source in the future for use in agriculture, essentially required to offset the food demand of a rapidly growing population. Moreover, the sustainable recovery of reclaimed water is essential for humanity to satisfy extreme sanitation and water-supply demands. To increase access to water supply, alternate water resources’ use, existing water resources’ degradation, and improved water-use efficiency are imperative. There is a high potential to address these factors by using reclaimed water as an alternative source. The reclaimed water treated at a tertiary level has the potential for use in crop production, especially for forage crops, irrigating urban landscapes, recreational and environmental activities, industry, and aquifer recharge to increase strategic water reserves in water-scarce countries. This way, we can save precious freshwater that can be utilized for other purposes. Eminently, freshwater applications for industrial and agronomic sectors account for 20% and 67%, respectively, depleting freshwater resources. The use of reclaimed water in agriculture can significantly reduce pressure on freshwater. However, if the quality of reclaimed water does not comply with international standards, it may cause serious health risks (diseases) and soil pollution (heavy metals).
The present study focuses on the validation and comparison of eight different physical models for soil salinity mapping in an arid landscape using two independent Landsat-Operational Land Imager (OLI) datasets: simulated and image data. The examined and compared models were previously developed for different semi-arid and arid geographic regions around the world, i.e., Latino-America, the Middle East, North and East Africa and Asia. These models integrate different spectral bands and unlike mathematical functions in their conceptualization. To achieve the objectives of the study, four main steps were completed. For simulated data, a field survey was organized, and 100 soil samples were collected with various degrees of salinity levels. The bidirectional reflectance factor was measured above each soil sample in a goniometric laboratory using an analytical spectral device (ASD) FieldSpec-4 Hi-Res spectroradiometer. These measurements were resampled and convolved in the solar-reflective bands of the Operational Land Imager (OLI) sensor using a radiative transfer code and the relative spectral response profiles characterizing the filters of the OLI sensor. Then, they were converted in terms of the considered models. Moreover, the OLI image acquired simultaneously with the field survey was radiometrically preprocessed, and the models were implemented to derive soil salinity maps. The laboratory analyses were performed to derive electrical conductivity (EC-Lab) from each soil sample for validation and comparison purposes. These steps were undertaken between predicted salinity (EC-Predicted) and the measured ground truth (EC-Lab) in the same way for simulated and image data using regression analysis (p ˂ 0.05), coefficient of determination (R2), and root mean square error (RMSE). Moreover, the derived maps were visually interpreted and validated by comparison with observations from the field visit, ancillary data (soil, geology, geomorphology and water table maps) and soil laboratory analyses. Regardless of data sources (simulated or image) or the validation mode, the results obtained show that the predictive models based on visible- and near-infrared (VNIR) bands and vegetation indices are inadequate for soil salinity prediction in an arid landscape due to serious signals confusion between the salt crust and soil optical properties in these spectral bands. The statistical tests revealed insignificant fits (R2 ≤ 0.41) with very high prediction errors (RMSE ≥ 0.65), while the model based on the second-order polynomial function and integrating the shortwave infrared (SWIR) bands provided the results of best fit, with the field observations (EC-Lab), yielding an R2 of 0.97 and a low overall RMSE of 0.13. These findings were corroborated by visual interpretation of derived maps and their validation by comparison with the ground truthing.
Higher sulfate concentration in Kuwait’s irrigation water poses serious risks to plant health, as many crops have limited tolerance for such high levels. The study is the first attempt in Kuwait to address the elevated sulfate concentrations in the clastic aquifer of northern Kuwait through numerical modeling and geochemical techniques. The geochemical analytical results reveal that groundwater in northern Kuwait is alkaline, with ion abundances in the order of Na⁺ > Ca2⁺ > Mg2⁺ > K⁺ and Cl− > SO₄2− > NO₃− > HCO₃−. Sulfate concentrations range from 1200 to 3865 mg/L, with the highest levels found in areas near agricultural zones, raising concerns about the viability of this groundwater for consumption and irrigation without treatment. A likely impact of anthropogenic influence due to the application of fertilizers is observed due to the good correlation between NO₃− and SO₄2−. Sulfide oxidation and sulfate mineral weathering also increase the concentration of SO₄2− ions in groundwater. Apart from oxidation, the inferences from geochmical modeling indicate dissolution as due to the undersaturation states of major sulfate minerals (gypsum/anhydrite). Numerical simulations further confirmed that the groundwater chemistry is driven by mineral dissolution, ion exchange, and anthropogenic influences, with key calibrated parameters including a longitudinal dispersivity of 10 m, an adsorption coefficient of 1 × 10−⁶ [1/(mg/L)], and a chemical reaction rate of 5 × 10−5 [1/day]. These findings underscore the critical need to manage sulfate levels in the aquifer to prevent adverse effects on water quality and usability, offering essential guidance for developing sustainable water management practices in northern Kuwait.