A study was performed involving a series of double-headed carboxylate collectors with varying distance between the head groups (one, two or three carbon atoms). A collector with the same alkyl chain length but with only one carboxylate group was also included. All these were amino-acid based amphiphiles and the polar head group was connected to the hydrophobic tail via an amide linkage. Selective flotation recovery of different calcium minerals using these collectors was investigated. The double-headed collector with one carbon atom between the carboxylate groups was an apatite and fluorite specific reagent while the monocarboxylate surfactant showed high specificity for calcite. The flotation behavior of a simple conventional collector of the same alkyl chain length, a fatty acid salt, was also determined under identical flotation conditions in order to understand the effect of the amide group. Complementary experiments (ζ potential measurements, adsorption isotherm determinations) were also performed for these reagents. In order to shed light on the selectivity obtained with the dicarboxylate surfactants, the distances between the head groups were calculated and compared with the distances between neighboring calcium atoms on the surface of the minerals. It was found that the high degree of selectivity could be rationalized by perfect matching of these distances. To the best of our knowledge this is the first study where flotation selectivity in complex calcium mineral systems has been explained in terms of molecular recognition governing the interaction between the collector and the mineral surface. Graphical Abstract
The rapid development of industry increases the demand and importance of chromium. In this study, beneficiation possibilities of the representative chromite ore taken from the Tokat Province with a laboratory type jig, spiral concentrator, shaking ta...
The interaction between chalcopyrite and illite particles was analysed using ζ-potential measurements and flotation tests. Statistically designed tests were used to examine the factors controlling flotation (frother concentration, dispersant concentration, froth height, airflow rate and amount of clay). Furthermore, the significance levels of the impacts of these factors on responses (chalcopyrite grade/recovery, pyrite grade/recovery, dynamic froth stability and mean bubble diameter) were determined. Chalcopyrite and pyrite ζ-potentials were measured in the presence of illite. The addition of 15% illite to the chalcopyrite, especially between pH 11 and 12, shifted the ζ-potential values closer to that of pure illite, indicating complete surface coating of chalcopyrite with illite. In the flotation experiments, better results were obtained in terms of chalcopyrite grade at a low airflow rate and a high froth height. With increasing froth height there was a decline in the gangue mineral recovery as the residence time of the froth increased. The most significant factor increasing pyrite recovery was the amount of clay. Although illite is considered to be the least problematic clay mineral for flotation, as reported in the literature, an illite content of as low as 5% in the ore decreased chalcopyrite grade by 3.83%. While K and Na contents of 4% were detected after flotation without the addition of illite, their abundance increased to 5.7% after the addition of illite.