Increasing plant density is one of the most efficient ways of increasing wheat (Triticum aestivumL.) grain production. However, overly dense plant populations have an increased risk of lodging. We examined lignin deposition during wheat stem development and the regulatory effects of plant density using the wheat cultivars shannong23 and weimai8. Plants were cultivated at densities of 75, 225 and 375 plants per m²during two growing seasons. Our results showed that decreasing plant density enhanced culm quality, as revealed by increased culm diameter, wall thickness and dry weight per unit length, and improved the structure of sclerenchyma and vascular bundles by increasing lignification. In addition, more lignins were deposited in the secondary cell walls, resulting in strong lodging resistance. The guaiacyl unit was the major component of lignin and there was a higher content of the syringyl unit than that of the hydroxybenzyl unit. Furthermore, we hypothesised that the syringyl unit may correlate with stem stiffness. We describe here, to the best of our knowledge, the systematic study of the mechanism involved in the regulation of stem breaking strength by plant density, particularly the effect of plant density on lignin biosynthesis and its relationship with lodging resistance in wheat.

Stay-green, a key trait of wheat, can not only increase the yield of wheat but also its resistance to heat stress during active photosynthesis. Cytokinins are the most potent general coordinator between the stay-green trait and senescence. The objectives of the present study were to identify and assess the effects of cytokinins on the photosynthetic organ and heat resistance in wheat. Two winter wheat cultivars, Wennong 6 (a stay-green cultivar) and Jimai 20 (a control cultivar), were subjected to heat stress treatment from 1 to 5 days after anthesis (DAA). The two cultivars were sprayed daily with 10 mg L^-1 of 6-benzylaminopurine (6-BA) between 1 and 3 DAA under ambient and elevated temperature conditions. We found that the heat stress significantly decreased the number of kernels per spike and the grain yield (P < 0.05). Heat stress also decreased the zeatin riboside (ZR) content, but increased the gibberellin (GA₃), indole-3-acetic acid (IAA), and abscisic acid (ABA) contents at 3 to 15 DAA. Application of 6-BA significantly (P < 0.05) increased the grain-filling rate, endosperm cell division rate, endosperm cell number, and 1,000-grain weight under heated condition. 6-BA application increased ZR and IAA contents at 3 to 28 DAA, but decreased GA₃ and ABA contents. The contents of ZR, ABA, and IAA in kernels were positively and significantly correlated with the grain-filling rate (P < 0.05), whereas GA₃ was counter-productive at 3 to 15 DAA. These results suggest that the decrease in grain yield under heat stress was due to a lower ZR content and a higher GA₃ content compared to that at elevated temperature during the early development of the kernels, which resulted in less kernel number and lower grain-filling rate. The results also provide essential information for further utilization of the cytokinin substances in the cultivation of heat-resistant wheat.

In winter wheat, grain development is asynchronous. The grain number and grain weight vary significantly at different spikelet and grain positions among wheat cultivars grown at different plant densities. In this study, two winter wheat (Triticum aestivum L.) cultivars, ‘Wennong6’ and ‘Jimai20’, were grown under four different plant densities for two seasons, in order to study the effect of plant density on the grain number and grain weight at different spikelet and grain positions. The results showed that the effects of spikelet and grain positions on grain weight varied with the grain number of spikelets. In both cultivars, the single-grain weight of the basal and middle two-grain spikelets was higher at the 2^nd grain position than that at the 1^st grain position, while the opposite occurred in the top two-grain spikelets. In the three-grain spikelets, the distribution of the single-grain weight was different between cultivars. In the four-grain spikelets of Wennong6, the single-grain weight was the highest at the 2^nd grain position, followed by the 1^st, 3^rd, and 4^th grain positions. Regardless of the spikelet and grain positions, the single-grain weight was the highest at the 1^st and 2^nd grain positions and the lowest at the 3^rd and 4^th grain positions. Overall, plant density affected the yield by controlling the seed-setting characteristics of the tiller spike. Therefore, wheat yield can be increased by decreasing the sterile basal and top spikelets and enhancing the grain weight at the 3^rd and 4^th grain positions, while maintaining it at the 1^st and 2^nd grain positions on the spikelet.