The active thermographic techniques are well-established for controlling composite components subjected to low-velocity impact damage. However, in recent years, the main works on thermographic techniques have focused on processing the raw data with the aim of increasing the signal-to-noise ratio and the probability of damage detection. It is well-known that assessing the residual strength of the material is crucial for quantifying the damage extension. In this regard, the aim of this work is to quantify the damage produced by impacted tests on hybrid woven composites by means of thermographic techniques. In particular, a novel procedure based on applying two filters frame by frame on the thermographic data obtained after applying the pulse thermographic technique was proposed, and information about the damage extension was provided. The results showed the possibility of quantitively estimating the damage and the effect of momentum in hybrid natural fiber composites.
This work investigates the feasibility of using thermographic techniques to identify the three possible states of a silicon-based coating on a carbon–silicon matrix (ISiComp). Experimental tests were therefore carried out on specimens prepared in three different conditions: uncoated, coated, and coated then oxidized. The study compares lock-in thermography and pulsed thermography using both a cooled mid-wave infrared (MWIR) camera and an uncooled long-wave infrared (LWIR) microbolometric camera. The main objective is to distinguish coated from uncoated conditions and oxidized from non-oxidized conditions, while recognizing that the coated and oxidized states cannot coexist simultaneously on the same specimen. The results show that thermographic techniques, when supported by appropriate post-processing, are promising for this purpose. In particular, the uncooled LWIR camera provided better results than the cooled MWIR camera, whereas the current approach did not allow a robust distinction between the pristine-coated and oxidized-coated states. At the same time, the study highlights limitations related to specimen size and to the additional treatments applied to reproduce the different surface states. Future work will address larger specimens and real components, together with the implementation of advanced AI-based classification algorithms to overcome the current limitations of the proposed approach.