An experimental study on the wave-induced gap resonance and resonant suppression scheme for two floating rectangular structures (TFRSs) is systematically presented. The instantaneous velocity fields for the present problem are measured using an enhanced underwater particle image velocimetry measurement system. Detailed experimental results have been presented to study the influences of the wave and structural parameters on the gap resonant characteristics. The resonant wave height and wave frequency were sensitive to the variation of the gap width but not very sensitive to the variation of the surface roughness on the rounded corner of TFRSs. The nonlinear effects of harmonic components on resonant free surface elevation are estimated. To analyze the vortex structures, different vortex identification methods in literature are analyzed and their merits and demerits are summarized based on a comparative analysis of the measured velocity data. The Ω-criterion vortex identification approach is then selected to evaluate the vortex intensity and capture the main vortex cores. Thanks to the adopted technique, the subsequent separation of the two quasi-symmetric vortex structures is considered to be a significant contribution to energy dissipation. The vortex shedding and dissipation modes of different TFRSs are very similar and exhibit slight variations in resonant responses. A formula of the modified Reynolds number for the gap resonance problem of TFRSs is proposed. The non-dimensional vortex strengths are nonlinearly dependent on the newly modified Reynolds number and linearly dependent on the Keulegan–Carpenter (KC) number. Finally, an optimal suppression scheme for the gap resonance problem of TFRSs is suggested.
This paper studies the hydrodynamic performance of vertical cylindrical absorbers in front of a vertical wall. All the absorbers are independent of each other and restricted to only the heave motion. Based on a linear potential flow theory, an analytical solution is developed for the problems of wave diffraction and radiation by absorbers. In the solving procedure, the hydrodynamic problem is first transformed into an equivalent problem in an open water domain using the image principle. The number of absorbers in the equivalent problem is twice that in the real problem, and the plane layout is symmetric about the original vertical wall. The velocity potential of the fluid domain is obtained using the method of variable separation, and the unknown expansion coefficients in the velocity potential are determined by the matched boundary conditions. The heave excitation force, added mass, radiation damping, motion response, and energy capture width of the absorbers are calculated. Case studies are presented to show the effects of the wall reflection and hydrodynamic interaction on the energy extraction performance of the wave energy converter (WEC) system. Subsequently, the WEC performance under the action of irregular waves is analyzed by considering an incident wave spectrum, and the mean annual absorbed power of the device is estimated by considering the wave data statistics at the actual sites. The results indicate that when the wave motion resonates with the absorber motion, the energy extraction performance of the absorbers is significantly improved. The performance of the absorbers can be effectively improved when the structures are close to the antinodes of a standing wave field. By designing a reasonable plane layout, the hydrodynamic interaction can play a constructive role in the performance of the WEC system.