High-performance on-chip coplanar-waveguide (CPW) transmission lines (TLs) were fabricated on locally formed porous silicon membranes on the Si wafer, and their millimeter-wave (mmW) characteristics were measured up to 110 GHz. It was demonstrated that a quality factor three times higher than that of conventional CPWs fabricated in standard CMOS on bulk crystalline Si can be obtained in mmW frequencies. The measured values of the attenuation loss were ~ 0.35 dB/mm at 60 GHz and ~ 0.55 dB/mm at 110 GHz. The obtained attenuation loss was independent of the realized TL characteristic impedance (50 and 145 Ω). These results are better than the state-of-the-art results in the literature obtained using CMOS on high-resistivity (HR) Si substrates (CMOS HR technologies). They show the potential of using locally formed porous Si membranes in mmW shielding on the Si wafer, in addition to the already demonstrated RF shielding (frequencies up to 40 GHz).
9 December 2015 in IEEE Transactions on Electron Devices
We report on the design, fabrication, and characterization of high-performance stepped-impedance filters (SIFs) on a locally formed porous Si layer on the CMOS Si wafer. This technology provides the appropriate platform to reduce the high losses within the Si substrate, along with the possibility to tune the substrate permittivity in order to achieve high characteristic impedance (ZC) transmission lines, which are important for the specific filters and other passive circuits, e.g., power dividers. By combining high-ZC coplanar waveguides (CPWs) and low-ZC slow-wave CPWs (S-CPWs), high-quality SIFs were achieved, with cutoff frequencies at 30 and 60 GHz. These SIFs were characterized in the frequency range of 0-100 GHz and demonstrated an insertion loss lower than 2 dB in the whole passband and a rejection higher than 30 dB in the stopband. The achieved performance is better than that exhibited by SIFs using only S-CPWs.
22 August 2018 in International Journal of Microwave and Wireless Technologies
This paper presents a miniaturized 3-dB branch-line coupler based on slow-wave microstrip transmission lines. The miniaturized coupler operating at 2.45 GHz is designed and implemented on a double-layer printed circuit board substrate with blind metallic vias embedded in the lower substrate layer providing the slow-wave effect. Based on this concept, a 43% size miniaturization is achieved as compared with a classical microstrip branch-line coupler prototype. The measured S parameters present a return loss of 25.5 dB and an average insertion loss equal to 0.05 dB at the operating frequency.
24 September 2008 in Microwave and Optical Technology Letters