During bone formation, collagen fibrils mineralize with carbonated hydroxyapatite, leading to a hybrid material with excellent properties. Other minerals are also known to nucleate within collagen in vitro. For a series of strontium- and calcium-based minerals, we observed that their precipitation leads to a contraction of collagen fibrils, reaching stresses as large as several megapascals. The magnitude of the stress depends on the type and amount of mineral. Using in-operando synchrotron x-ray scattering, we analyzed the kinetics of mineral deposition. Whereas no contraction occurs when the mineral deposits outside fibrils only, intrafibrillar mineralization generates fibril contraction. This chemomechanical effect occurs with collagen fully immersed in water and generates a mineral-collagen composite with tensile fibers, reminiscent of the principle of reinforced concrete.

A reduction in the particle size is expected to improve the properties and increase the application potential of high-entropy alloys. Therefore, in this study, a novel sol–gel autocombustion technique was first used to synthesize high-entropy alloys. The average grain size of the prepared nanocrystalline CoCrCuNiAl high-entropy alloys showed was 14 nm with an excellent and uniform dispersion, exhibiting a distinct magnetic behavior similar to the superparamagnetic behavior. We show that the metal nitrates first form (Co,Cu,Mg,Ni,Zn)O high-entropy oxides, and then in situ reduce to CoCrCuNiAl high-entropy alloys by the reducing gases, and the chelation between citric acid and the metal ions and the in situ chemical reactions are the dominant reaction mechanisms. We demonstrate that the sol–gel autocombustion process is an efficient way to synthesize solid solution alloys eluding the restriction of a high mixing entropy.

Phase transformation of amorphous silica to cristobalite at a relatively low temperature of 800 °C has been achieved on bacterial surfaces.

As environmental and energy problems have worsened worldwide, research for developing renewable energy has become urgent. Presently, the primary focus of such research is directed towards the photocatalytic decomposition of water to produce hydrogen as an energy source. Herein, ZnO nanosheet/CdS nanoparticle heterostructures were synthesized by a mild wet chemical reaction and displayed a high photocatalytic efficiency (1040 μmol g⁻¹ h⁻¹) without Pt loading under visible light radiation. The structure was prepared by first constructing two-dimensional nanocrystalline ZnO flowers and then loading CdS nanoparticles onto the nanocrystals. Results show that this structure can facilitate the separation of photogenerated electrons and holes and improve the photocatalytic efficiency and stability of the materials in the photocatalytic decomposition of water. By changing different experimental conditions to prepare a variety of samples and test their properties, we can analyze the optimal parameters for the preparation of this material.