It is well known that the performance of magnetoelectric properties in multiferroic materials is dependent on the electric poling conditions. Few reports, however, have investigated electric poled state effects on their magnetic properties. In this paper, M-H hysteresis loops were monitored from 5 K up to room temperature, for both unpoled and poled 0.80{0.675[Pb(Mg1/3Nb2/3)O3-0.325PbTiO3]}-0.20[CoFe2O4] particulate composites. The study was performed for samples with average grain size of 0.8 µm and 4.4 µm. Magnetoelectric voltage response was also evaluated for samples poled under 20kV/cm, 30 min., at different temperatures. The results show that the magnetic anisotropy is strengthened by remanent electric polarization, probably due to an enhancement of the strain anisotropy at the biphasic grain boundaries, which depends upon the grain size distribution.
This paper reports the electric, magnetic and magnetoelectric properties of particulate composites of the system with ferroelectric phase 0.675[Pb(Mg1/3Nb2/3)O3]−0.325[PbTiO3] and magnetic phase CoFe2O4 prepared by Spark Plasma Sintering technique. Optimized sintering and thermal annealing parameters were applied in order to achieve highly dense microstructure with sub micrometric grain size distribution for both phases. The results from the dielectric measurements showed a diffuse and dispersive phase transition. P-E and M-H loops revealed the simultaneous existence of ferroelectric and ferrimagnetic ordering, respectively. Moreover, at cryogenic temperatures an anomalous behavior on the bias magnetic field dependence was observed for the magnetoelectric voltage coefficient.
6 February 2025 in Journal of Southwest Jiaotong University
This study aims to investigate the electric, magnetic, and magnetoelectric properties for the lead zirconate titanate-cobalt ferrite particulate multiferroic composite, Pb(Zr0.52Ti0.48)O3/CoFe2O4.The composites were synthesized utilizing the Pechini method and thermally sintered employing a microwave oven and a conventional method. Two molar ratios, 80/20 and 50/50, of the constituents' phases were utilized to analyze the effect of grain size on properties. The results of X-ray diffraction (XRD) patterns indicated no formation of secondary phases for powder phases and ceramic composites. The micrographs exhibited the distribution of magnetic grains in the ferroelectric matrix and displayed 0-3 connectivity. The dielectric constants, electric resistivity, and ferroelectric properties demonstrated a decrease in their values between approximately 10% and 20% for composites sintered by the microwave-oven method, which was attributed to the decrease in the grain size of the ferroelectric phase and the molar increase of the magnetic phase, resulting in electrical losses due to the presence of a non-ferroelectric phase. The magnetic hysteresis and magnetostriction coefficients exhibited higher values for the microwave-oven method than the conventional method as the magnetic anisotropy effect is more pronounced for smaller ferrite grain sizes. The induced voltage via magnetoelectric coupling was observed for all composites. The composites produced by microwave sintering (MS) exhibited higher voltage values than those produced by conventional sintering (CS). However, the magnetoelectric coefficients for composites with a 50/50 molar ratio were lower than those with an 80/20 molar ratio, which was potentially attributed to the reduction in ferroelectric grain size and increased electrical losses. Consequently, these results demonstrate a novel approach to improve performance and potential applications for functional devices.
This study examines the dynamics of two spheres falling independently in a viscous fluid, highlighting conditions under which a lighter sphere can achieve a higher velocity than a heavier one. Through theoretical modeling and simulations, the motion of spheres with varying densities and radii, released simultaneously in a uniform viscous medium, was analyzed. The investigation considers gravitational, buoyant, and drag forces, with the spheres moving under identical initial conditions and without mutual interaction. The results confirm the well-established case where the heavier sphere exhibits a greater terminal velocity. However, an intriguing phenomenon is identified: under specific conditions, a lighter sphere can surpass its counterpart in terminal velocity. Additionally, when spheres of equal weight are compared, the denser sphere consistently attains a higher terminal velocity. The study reveals non-trivial time-dependent acceleration patterns, with alternating dominance between heavier and lighter spheres before terminal velocities are reached. Furthermore, the order of impact with the ground is shown to depend on the release height, illustrating a complex interplay of forces. These findings offer novel insights into fluid dynamics, with implications for education and engineering applications.
In this work, the cobalt ferrite ceramic was synthesized by using Pechini and densified using two different sintering routes: conventional sintering (CS) at 1200 °C for 3 h and microwave sintering (MS) at 1200 °C for 15 min. The influence of both sintering methods on the structural, microstructural, magnetic, and magnetostrictive properties was investigated. X-ray diffraction and Rietveld refinement confirmed the formation of a single-phase cubic spinel structure (Fd-3m) without secondary phases for both samples, and the crystal structure parameters exhibited only minor variations, indicating that the crystal structure remained essentially unaffected by the sintering route. In contrast, SEM micrographs revealed a remarkable reduction in average grain size from 7.72 µm (CS) to 0.74 µm (MS), demonstrating the effectiveness of microwave sintering in controlling grain growth (≈90% reduction in grain size). The magnetic measurements showed slightly higher saturation magnetization and coercive field values for sample MS, which were associated with the refined microstructure and enhanced magnetic anisotropy. Magnetostriction curves at room temperature yielded saturation values of −120 × 10−6 (CS) and −110 × 10−6 (MS) for samples, respectively. Despite the lower saturation magnetostriction, the microwave-sintered sample exhibited a significantly higher piezomagnetic coefficient (66 × 10−5 T−1) compared with the conventional sintered sample (35 × 10−5 T−1), it showed ≈8% decrease in saturation magnetostriction and ≈89% increase in piezomagnetic coefficient. Furthermore, a sign reversal of the magnetostrictive response was observed near 0.40 T for the MS sample, suggesting competition between magnetoelastic contributions associated with different crystallographic directions. The unstressed magnetostriction model successfully reproduced the experimental magnetostriction curves, confirming that grain-size refinement and grain-boundary effects play a dominant role in governing the magnetomechanical response of magnetic ceramics.