The effect of reduced corn evapotranspiration (ET) during solid-set sprinkler irrigation on application efficiency was analyzed on two subplots. During each irrigation event, one subplot was irrigated (moist treatment) while the other was not (dry treatment). ET (weighing lysimeter) and transpiration (heat balance method) rates were determined at each subplot before, during, and after the irrigations. During daytime irrigations, there was a significant decrease in ET (32–55%) and transpiration (58%) for the moist treatment. After the irrigations (1–2 h) , ET significantly increased (34%) and transpiration decreased (20%). Gross wind drift and evaporation losses ( WDELg ) were found to be 19.3% of the applied water. Taking into account the ET changes during and after the irrigations, net sprinkler evaporation losses ( SELn ) were 14.4–17.5% of the applied water. During nighttime irrigations, changes in ET and transpiration were almost negligible, and SELn were slightly greater than WDELg (9.5 and 8.1%, res...

A model of solute transport in overland flow is developed and applied to the simulation of surface fertigation. Water flow is simulated using the depth-averaged, 1D shallow water equations. Solute flow is represented by an advection-diffusion model. The resulting set of three partial differential equations is sequentially solved at each time step. First, water flow is computed using the explicit two-step McCormack method. Based on the obtained velocity field, solute transport is explicitly determined from the advection-diffusion equation using the operator split technique. Four field experiments involving fertigation events on an impervious free-draining border were performed to validate the proposed model and to obtain estimates of Kx, the longitudinal dispersion coefficient. A value of Kx = 0.075 m2 s−1 satisfactorily reproduces the field experiments. The model is also applied to the simulation of a fertigation event on a pervious border. A sensitivity analysis is performed to assess the dependence of f...

42 Pags.- 5 Tabls.- 8 Figs. The definitive version is available at: http://www.sciencedirect.com/science/journal/03783774Water and energy are limited and expensive resources. Conserving water and energy is a requirement to ensure the viability of modern pressurized irrigation systems. The objective of this research was to analyze the possibilities of reducing the nozzle operating pressure of impact sprinklers from 300 kPa (standard pressure) to 200 kPa (low pressure) in solid-set irrigation systems without reducing the sprinkler spacing and maintaining crop yield. Three treatments resulting from combinations of sprinkler type, and working pressure were analyzed: 1) Conventional impact sprinkler operating at 300 kPa (CIS300); 2) Conventional impact sprinkler operating at 200 kPa (CIS200); and 3) Modified deflecting plate impact sprinkler operating at 200 kPa (DPIS200). A randomized experimental design was applied to a maize crop during two seasons (2015 and 2016). Irrigation performance was measured by catch-can monitoring at one replicate of each treatment. Maize growth, yield and its components were measured. Differences between treatments in soil water, maize growth and yield variables were analyzed using ANOVA. Seasonal irrigation uniformity evaluated at the top of the canopy was larger for the standard pressure treatment (93%) than for the low pressure treatments (82% and 84% for DPIS200 and CIS200, respectively). The average wind drift and evaporation losses for the 2016 irrigation season were higher for the CIS300 treatment (17%) than for the low pressure treatments, DPIS200 (15%) and CIS200 (13%). Low pressure treatments did not reduce grain yield compared with the standard pressure treatment. Differences in irrigation performance and maize yield between the low pressure treatments, DPIS200 and CIS200, were not statistically significant. The reduction in energy use by reducing the operating pressure from 300 kPa to 200 kPa would allow to increase the net farming benefit of individual and collective systems. This is particularly true if low pressure irrigation is considered at the design phase of the irrigation system.This research was funded by MICINN of the Government of Spain through grant AGL2013-48728-C2-1-R. Octavio Robles has a scholarship funded by the Minister of Economy and Competitiveness of the Spanish Government.Peer reviewe