In order to reduce the influence of coupling capacitance variations on cable voltage measurement, this paper proposes a self-compensating non-intrusive ring-type AC voltage sensor based on capacitive coupling. A theoretical model of the sensor was established, and the influence of parasitic capacitance changes on sensor output was analyzed. Furthermore, a theoretical analysis shows that the parasitic capacitance between the external cable and the sensing probe, as well as between the ground and the sensing probe, will significantly affect the sensitivity of the sensor and increases the measurement error. A ring-type inductive probe and a signal processing circuit were designed, incorporating a reference signal to compensate for the influence of coupling capacitance variations. Additionally, to minimize the impact of parasitic capacitance on sensor output, the length of the outer ring electrode was extended, and a PTFE housing was designed for protection. A prototype of the sensor was developed and tested. This prototype has a good linear response to AC voltage in the measurement range of 0–1000 V with a linearity of 0.86%. The effects of changes in cable diameter and cable position on the measurement were tested separately. The worst-case error of the sensor output is less than 6.44%, representing a reduction of 21.4% compared to the uncompensated case. Under external cable interference, the sensor exhibited an output error of less than 1.85%. The results show that the designed sensor can accurately measure cable voltage despite changes in cable diameter or installation position, and also demonstrates effective shielding against external interference.
To mitigate the three-dimensional (3D) coupling interference of electric field sensors, a novel MEMS 3D electric field sensor with a dual-orthogonal induction structure and its spatial decoupling method is proposed. The sensor is designed with a cylindrical structure, in which two pairs of induction electrodes are orthogonally arranged to suppress common-mode interference. MEMS electric field sensing chips are utilized to achieve 3D electric field measurement. Furthermore, a spatial decoupling calibration model is established based on the structural characteristics of the sensor. The Cramér–Rao lower bound of the linear model is calculated to obtain the optimal decoupled calibration matrix, enabling precise 3D electric field decoupling. Experimental results showed that within an electric field range of 0–50 kV/m, the linearity of the three decoupled electric field components was 2.60%, 1.20%, and 1.78%, respectively, while the synthesized electric field achieved a linearity of 0.74% with a maximum full-scale error of 0.80%. Under varying angles and field intensities, the maximum and average relative errors of the decoupled synthesized electric field were 1.20% and 0.43%, respectively, representing reductions of 61.8% and 56.1% compared to the conventional matrix inversion method. These results confirmed that the proposed method effectively suppressed coupling interference and enhanced 3D electric field measurement accuracy.