Poor soil health and low soil water content during crop growing period are major factor for low productivity of pearl millet – mustard rotation under rainfed semi-arid regions. The authors evaluated five different tillage and residue management practices for improving physico–chemical and biological properties of soil. Results showed that conservation agriculture (CA) practice (zero tillage (ZT) with 4 t ha^–1 residue retention) exhibited higher proportion of soil macro-aggregate. It also increased infiltration rate of about 15.2% over conventional tillage without residue but ZT increased soil penetration resistance in surface soil layer. In the residue applied plots, ~2–4% (w/w) higher soil water content was maintained throughout the season than the no-residue plots. CA practice had the highest soil organic carbon (4.96 g kg^–1) and microbial biomass carbon (188.3 μg g^–1 soil). Significant and positive correlation was also found between soil organic carbon with infiltration rate (r = 0.73**), mean weight diameter (r = 0.80**) and microbial biomass carbon (r = 0.86**). Thus, this study suggests that ZT with residue retention can be advocated in pearl millet – mustard rotations for improving, productivity, soil health and maintaining higher soil water content in rainfed semi-arid regions.

Tillage is an important agricultural operation which influences soil properties, crop yield and environment. Nine combinations of three tillage practices including conventional tillage (CT), minimum tillage (MT) and zero tillage (ZT) were evaluated in fodder sorghum (Sorghum bicolor) + cowpea (Vigna unguiculata) – wheat (Triticum durum) cropping system for 5 years (2009–2014) on clay loam soil under limited irrigation. Continuous ZT practices significantly improved surface soil organic carbon, bulk density, infiltration rate and maximum water holding capacity. Carbon sequestration rate, soil organic carbon stock and soil enzymatic activities were relatively more under ZT than CT-CT practice. Higher fodder yield of sorghum + cowpea was recorded with CT (kharif) while wheat grain yield with ZT (rabi). However, the system productivity was statistically similar in all the tillage treatments on pooled data basis. The economic benefits were also maximum under ZT-ZT practice. The ZT-ZT practice recorded significantly lowest energy input (17.1 GJ ha⁻¹) which resulted in highest energy use efficiency (13.6) and energy productivity (518 kg GJ⁻¹). Thus, adoption of ZT significantly improved soil health, stabilized crop yield, increased profitability and energy use efficiency in the semi-arid agro-ecosystem.

Field experiments were conducted to evaluate the effects of zinc (Zn) fertilization on yield potentiality and quality of promising wheat varieties during winter seasons of 2013–14 and 2014–15 at the research farm of the Indian Agricultural Research Institute, New Delhi. Among genotypes, HD 2967 genotype proved as best in realizing the highest grain yield (4.89 Mg ha⁻¹), net returns and benefit–cost ratio besides increased protein (13.4%) and wet gluten (29.4%) content in grain. Highest grain Zn concentration and recovery efficiency (RE) recorded in HD 2851 and HD 2687, respectively. HD 2932 registered lowest grain hardiness index (GHI) followed by PBW 343, indicating their better bread-making quality. With respect to Zn fertilization, application of 1.25 kg Zn Zn–ethylene diamine tetra acetic acid (Zn–EDTA) + 0.5% foliar spray at maximum tillering and booting stages resulted in the highest yields, grain Zn concentration and RE followed by 2.5 kg Zn (ZnSO₄·7H₂O) + 0.5% foliar spray at both stages. These treatments are also superior most with respect to grain quality parameters such as protein, wet gluten and starch content. From profitability viewpoint, 2.5 kg Zn (ZnSO₄·7H₂O) + 0.5% two foliar sprays were most remunerative with maximum net returns and benefit–cost ratio.