This study aims to investigate the joint strength of longitudinal plate-to-high-strength steel circular hollow-section X-type joints under plate axial load. The material properties of high-strength steel with nominal yield strengths of 460, 650, 900, and 1100 MPa were used for parametric analysis. The variables for analysis were ratios of chord diameter to thickness, plate width to chord diameter, and utilization. To determine the capacity of connections, the joint strengths using a deformation limit and a strength limit were considered and compared with American Institute of Steel Construction (AISC), Eurocode 3, and ISO 14346. The joint strength determined by the ultimate deformation limit is approximately equal to the joint strength determined by the strength limit state at the yield strength of 460 MPa. The difference between both the joint strengths, however, becomes higher with increasing yield strength. The design equations estimate the joint strength based on the ultimate deformation limit approximately until the limitation of the nominal yield strength in each design code. As the nominal yield strength increases, the joint strengths are overestimated. In using high-strength steel in circular hollow-section X-type joints, the reduction factors of 0.75 and 0.62 for AISC and ISO 14346 are suggested for the nominal yield strengths of 900 and 1100 MPa, respectively. In Eurocode 3, the reduction factor of 0.67 is also suggested for a yield strength of 1100 MPa.