With the increase in exploration in recent years, buried hill condensate gas reservoirs have gradually become an important field for increasing reserves and production of offshore oil and gas in China, and efficient development of condensate gas reservoirs has also become a hot issue in hydrocarbon development. Due to the complex phase-change law and retrograde condensation phenomenon of deep condensate gas reservoirs, the reservoir properties and production dynamics data obtained by conventional pressure-recovery-test methods were greatly limited, and the dynamic data and evaluation parameters of the single well control area cannot be accurately determined. In this paper, using the production analysis method to analyze the production dynamics data of a single well, combined with static geological data and well-test analysis data, the reservoir parameters of a single well were evaluated. Specifically, the Blasingame method was applied to realize the production-decline law of production wells, and new dimensionless flow, pressure parameters, and pseudo-time functions were introduced. Using the unstable well test theory and the traditional production decline analysis technology, the IHS Harmony software is used to fit the production dynamic data with the theoretical chart. The evaluation parameters such as reservoir permeability, skin factor, well control radius, and well control reserves were calculated, providing strong support for the production decision-making of the petroleum industry and also providing a strong decision-making basis for the dynamic adjustment of oil–gas-well manufacture.
With the development of tracer technology and the improvement of fine management in oil fields, chemical tracer monitoring is widely used to analyze the production profiles in commingled wells and horizontal wells. However, most existing tracer technologies can only determine the production profile and cannot calculate the water cut. This paper proposes an intelligent slow-release chemical tracer monitoring technology and a corresponding interpretation methodology, which can quantify the oil and water production rates and dynamically analyze the water cut of production profiles by simultaneous deployment of oil-soluble and water-soluble tracers. To validate this approach, this method was applied to well A of the Bohai Oilfield. The results showed that the calculation model based on produced tracer concentration can quantitatively determine the production profile and water cut of the monitored well. During the stable production period, Well A exhibited high production rates and a low water cut, and the contribution of oil production varied greatly among different layers. The first and third sections were identified as the main contributors, accounting for 51.8% and 23.2% of production, respectively, while the second and fourth sections showed lower contributions of 15.1% and 9.9%. The water cut of each section was below 30%. This intelligent slow-release tracer monitoring technology allowed for continuous production profiles in the monitored well. The proposed method provides effective guidance for characterizing the production profile and water flooding patterns of each layer. It is helpful for the efficient development of oil and gas reservoirs.