In recent years, heat treatment has attracted attention as a means to improve the color sorting technology with the aim of improving the quality of low-grade limestone. The crucial stage in this technique is to evaluate the breakage characteristics of the sample materials after color sorting. In this study, the breakage characteristics of samples showing color differences after heat treatment and of the original raw material were investigated using a laboratory ball mill. The grinding was characterized using the population balance model. Specific rates of breakage and the primary breakage distribution were experimentally determined by first-order kinetic plots and the BII method. The breakage parameters were also back-calculated by employing a simplex method. Grinding of the three materials indicated first-order kinetics, and the experimental results were well described by the model with parameters obtained by back-calculating.

End-of-life vehicles (ELVs) contain valuable materials such as ferrous metal 75%. The dismantling ELVs typically requires the manual separation for removing the most hazardous materials and the mechanical recovery for recycling recyclable materials. After this process, the remaining materials are referred to as automotive shredder residue (ASR). For recycling ASR, wet treatments used in most of the plants require additional processing which increases the overall operating costs and decreases throughput. Therefore, to address these problems, a newly designed air table was applied. We then analyzed the quality and recovery rate of various materials. By using this method, we achieved ELVs recycling rate of 95%.

Due to depletion of resources and the spread of environmental pollution, the sustainability of raw materials is emerging as an important issue. Glass bottles are one of the products that are easy to recycle, and many studies have been conducted to improve the recycling rate. In this study, we attempted to develop the waste glass bottles process that can be recycled into a glass cullet and recycled glass aggregate. To produce a cullet from waste glass bottles(WGBs), color quality standards must be satisfied. Therefore, we applied a multistage color sorter to the experiment. The recycled aggregate glass must adjust the particle size. Thus, we experimented with the optimum crusher selection test when applying the crushing process. And, we confirmed the appropriateness of process by aspect ratio analysis of product. In addition, we confirmed the trends in the data required to set the optimum design and operating conditions of the selected vertical shaft impact(VSI) crusher using discrete element method(DEM) simulations.