The unsuitable disposal of plastic wastes has caused serious environmental pollution, and finding a green manner to address this problem has aroused wide concern. Plastic wastes, especially polyolefin wastes, are rich in carbon and hydrogen, and chemical recycling shows distinct advantages in their conversion into olefins and realizes a closed-loop cycling of plastic wastes. Plastic wastes should be labeled before disposal. The necessity for, and methods of, pretreatment are introduced in this paper and the whole recycling process of polyolefin wastes is also summarized. As the core technology pyrolysis, including thermal, catalytic and solvolysis processes, is introduced in detail due to its potential for future development. We also briefly describe the feasible strategies of pyrolytic oil refining and life cycle assessment of the chemical recycling process. In addition, suggestions and perspectives concerning the industrial improvement of polyolefin chemical recycling are proposed.
19 February 2024 in Journal of Colloid and Interface Science
The production of light olefins from polyethylene (PE) has significant industrial potential. Zeolites have been widely used in petroleum refining for their ability to cleave C–C/C–H bonds and facilitate light olefins selectivity, thanks to their adjustable acidity and pore structure. However, the interaction between zeolites and conventional hydrocarbons or polymer reactants is quite different, a distinction frequently overlooked but has great influence on their reaction. Based on this, we describe a PE self-confined cracking mechanism that can produce C3-C8 olefins with exceptional yields, surpassing 70% under mild conditions (300 °C). Interestingly, the product distribution is only dependent on the degree of self-confinement and melt mass-flow rate (MFR) of PE, regardless of the porous structure, metal content, and internal acid properties of zeolite. Most importantly, this process allows for flexible tandem catalytic reforming to yield more than 67% C2–C4 light olefins and 23% separable BTX, demonstrating great potential to promote chemical recycling of waste polyolefin plastics.
The light cycle oil (LCO) hydrocracking process converts polycyclic aromatics into highly valuable light aromatics such as benzene, toluene, xylene (BTX), in accordance with the requirements of low-carbon development and high-quality transformation from oil refining to chemical industry. The accessibility of acid sites is a critical factor that impacts LCO conversion and BTX yield. Initially, the fine structure and molecular size of the typical polycyclic aromatics in LCO and their hydrogenation reaction intermediates were investigated through gas chromatography-mass spectrometry (GC-MS) analysis and density functional theory (DFT) calculations. Three porous Y zeolites with comparable Si/Al molar atomic ratios and pyridine (Py)-measured Brønsted acid amounts were chosen as an acidic component to prepare NiMo/(Al2O3 + HY) catalysts. The acid accessibility of HY zeolite was characterized via dual-beam infrared spectroscopy using 2,4,6-tri-tert-butylpyridine (2,4,6-TTBPy) and trihexylamine (THA) as probe molecules, and the LCO hydrocracking performance was evaluated on a fixed-bed reactor. The results revealed that bicyclic aromatic hydrocarbons featuring multiple, short side chains such as dimethylnaphthalene and trimethylnaphthalene are the main components of LCO, with sizes larger than those of HY zeolite micropores. There is a strong positive correlation between LCO conversion and ring-opening rate of polycyclic aromatics and cycloalkanes in LCO. Among these three HY zeolite catalysts, the ring-opening rates of polycyclic aromatics and cycloalkanes, and the yields of C6-C12 aromatics and BTX increased in the order of HY1 < HY2 < HY3, which is consistent with external surface acidity measured by THA as the probe molecule.