The objective of the study was to study soil water conservation and physiological growth of oat (Avena sativa L.) using water-saving superabsorbent polymer (SAP) at 60 kg ha−1. The effectiveness of SAP was studied under three irrigation levels (adequate, moderate, and deficient) using a new type of negative hydraulic pressure–controlled auto-irrigator. Seven weeks after sowing (WAS), the number of tillers and leaves increased significantly by 33 and 40%, respectively, under deficient irrigation due to application of SAP. The SAP had little effects on shoot dry mass (SDM) and root dry mass (RDM) under adequate and moderate irrigation but increased both parameters significantly (59 and 45%) under deficient irrigation. As a result, the water-use efficiency (WUE) increased substantially (50%) under deficient irrigation. Leaf water potential (ψ1) under adequate irrigation exceeded that under moderate and deficient irrigation by 26.4 and 39.6%, respectively, and the application of SAP further increased it by 7.2%. The superior growth and WUE of oat treated with SAP under deficient irrigation was ascribed to maintenance of greater relative water content (RWC) in leaves as well as intercellular carbon dioxide concentration (Ci), net photosynthesis (PN), and transpiration rate. It is suggested that the application of SAP is a suitable soil management practice for locations characterized by severe water stress.
15 July 2025 in Materials Science and Engineering: B
Temperature sensors with a negative temperature coefficient are widely used in various sectors because of their numerous benefits and practical applications. However, linearity over narrow ranges restricts extensive use compared to other temperature sensors, especially in the cryogenic region. This study investigated tantalum oxide (TaxO5−y) thin films and their potential for temperature sensing capabilities spanning the cryogenics to the room-temperature region due to their strong chemical, physical, and electrical properties, such as a wide bandgap, chemical stability, high refractive index, and dielectric constant. The properties of thin films partially depend on fabrication techniques/parameters. This research uses the high-power impulse reactive sputter technique to produce TaxO5−y thin films. The thin film of 200 nm TaxO5−y depends on temperature, and the resistance vs temperature (R-T) shows almost linear relationships in the 20–320 K range. The absolute value of the temperature coefficient of resistance of this sensor at 294 K increased to −1.1% K−1 as it grew. The annealing effect on R-T properties, including physical and crystalline characteristics, was investigated for optimization, and bandgap energy was found to be 4.16 ± 0.025 eV. Annealing at different temperatures causes a decrease in resistance and a slight change in the R-T curve due to its crystallization.